heater

Hi all, Not sure if I have a problem or its way the system is... ?? Noticed I can't always set the fan speed to the speed I want and appears to depend on the outside temp/ requested interior temp setting so suspect its just way system is. Often I can't select fan speed 2 or speed 3, the...

Just noted our T6 Caravelle isn't changing the temp of the climate control on the drivers side (ie the display shows 26 but blows almost as cold as 18). I've tried multiple settings to see if whatever gubbins are controlling the direction of the air can be 'nudged' back to working. So far...

Hi All, Does anyone know where the fuse is for the Aircon/heat director control panel (the one below the stereo)? Mine has stopped working as follows: - There is no LED backlight - The left hand knob (temperature control) doesnt do anything - The middle knob (heater fan speed control) works...

Heater does not work only get heat when on blower number 4 ...is this just the resister unit faulty . I have seen on u tube i guy changing one seems pretty straight forward . My question is is the faulty resister also responsible for not getting any heat before the fan is turn on . cheers .

Hi Chaps Just noticed tonight my heater blower is only working on speed 4. I’ve got the manual Air Con, rather than climate. All other functionality works ok, just nothing blowing out until you select the fan blower at speed setting 4. Anything obvious to check? Any known issues? Thanks

trying to get my heater to blow hot, had it on vagcom and it says “motor for temp flap” had all lower dash off today and cant find anything, but found this behind glove box: should it be connected

any ideas how to get to this

Hi guys. The heater controls on my van have stopped working and have blown the fuse, I’ve tried replacing the fuse but within 2 miles it had gone again. Just wondering if anyone has had a similar problem? thanks in advance

Any help on what I should be checking, tomorrow I will check coolant levels after that I’m a bit lost!....thanks for any help

my dashboard heater started blowing luke warm yesterday, i took the trim off and pulled the unit out as far as it could. The plastic gear for the hot and cold dial has broken somehow. Does anyone know if i can buy this part separately and if so , whats the easiest way to replace it please ? @Pauly

Hi all had my t6 for about 2 weeks and I've noticed no matter where dial is it only blows warmish ,also aircon not cold anybody any ideas

Can anybody help with this Address 08: Auto HVAC Labels: 7E5-907-047.clb Control Module Part Number: 7E0 907 047 AK HW: 7E0 907 047 AK Component and/or Version: Climatic-T5 H22 0708 Software Coding: 0000000003 Work Shop Code: WSC 02737 790 50316...

hi any advice appreciated..just swapped my t5 for a t6 panel van 2016..blowers are working fine on windscreen and feet but not much air is coming out of vents...will this be a cable issue ? there doesn't seem any tension on the dial etc... thanks in advance.. mark

Can anyone point me in the direction of somewhere that can do all three of stereo speaker upgrade - dc / dc battery install and Webasto. Does this type of magician even exist or will I have to just put the van into different places for the different pieces of work?

In my old T5.1 I used to keep the heater temp at the mid point, which was 22 degrees. I’ve done 250 miles in my new T6 and I’ve noticed the van gets red hot when I set it at that temperature. I have to turn it virtually down to get it to cool down. It seems worse(hotter)when the heater is set to...

Whenever I put the heating down to my feet, after 10-20minutes i get a warning on the stereo that its overheating. My feet at this point are still cold and theres not much coming from the air outlet at the feet. I've never had the dash off or anything so I have no idea what could be going on...

All required components are already purchased, tested and ready for the installation. Well invested €58=£49 :thumbsup: My ODIS-E is also ready to upload new(better) firmware ;)

Good evening all, Trying to unlock my Webasto Auxillary Heater via VCDS but struggling. I've tried clearing the failed start codes but unsuccessful. I have gone into adaptions and I believe I need to change a 0 to a 1 in a specific channel. But I have drop down options instead of channels...

Hi Folks Newbie here, just got myself a 2016 T6 Kombi and I have noticed it's got the old blower only works on #4 issue, I know this has been done several times as I've done a search but the one thing I can't find the answer to is how do you get to it, I know it's behind the glove box somewhere...

Hi, Can anybody enlighten me as to the fuse location for aircon control illumination, or any other reason why the AC light and Recirculation lights are not working. Thanks.