Was away for 3 nights last week and destroyed a electricial cable running the mains in through the front door to run a heater and dehumidifier.
There's no way im cutting a standard hole in the side of the van as its not a camper and I don't want it to look like one, I already have a anderson...
I want to piggyback onto the rear offsite brake light wire in order to use this in conjunction with the 12v NET signal from the EHU, so that I can activate a warning buzzer if I try to drive off with the EHU still connected. Is there an easy way of accessing this wire at the back of the van on...
This CU was fitted by a converter. Im relocating it atm to under bonnet but the wiring looks wrong way round to me - at least based on interior CUs.
In the top of the CU live is on left, neutral on right. Am I going crazy or isnt it usually the other way around? Does it even matter in a single...
My electric hook up point is located under the bonnet,so with the bonnet closed and ehu plugged in,battery charger located in a cupboard it’s very hard to see!,my worst nightmare would be to drive off while on hook up! Or parked on the drive plugged into the house, so I decided to use an ESP...
Looking to resite my HUP from below rear bumper to the engine area - problem is my consumer unit is in the back quarter panel and id prefer not to move it (would require removing furniture, finding a new site, making a new quarter panel etc)..
I have excess cable as this was always on longer...
People have been great helping me, so I thought I'd post a few pics of my van. This show my EHU and water arrangements the rear molding is held in place with two magnets you can see one of the striker plates in the photo. There is a shock corded tether as a backup, but it is very secure. I have...
With the state of the world as it is at the moment, the van isn't going to get much use.
So just wondered what's best for the leisure battery? To...
a) Leave the van on EHU from the house?
b) Just leave it to run flat (I think this is not good?)
c) EHU every week or so to fully charge, then...
Good morning
I have a westfalia Kepler 1 t6 Campervan, and wondered if someone had any experience of using a 12v microwave in such a van either of leisure batteries or mains hook up ?
Thank you
At the minute, I have an EHU extension lead with a RCD and breaker built in to it. I run this into the van and plug my battery charger in when needed.
I'm toying with the idea of fitting it permanently. Would there be anything wrong in fitting the EHU socket under the bonnet with an...
Would it be a bad idea to let a single gang unswitched mains socket into the side of a consumer unit under the drivers seat?
It looks like there is plenty of room in the unit, good space between the internals.
The idea is to retain the mains plug on the Victron charger so that I can easily...
Hello guys,
currently undergoing installation of my leisure battery and split charger for the use of USB and 12V sockets (nothing too serious)
We go camping a fair bit... and wondered if it was worth going with travel volts https://www.travelvolts.net/product-page/victron-ip-65-12-10-charger...
Hi, is there something available which will allow me to connect a 240 volt hook up directly to the main battery so I can using the lights etc in the back of my van when I'm on a camp site with draining my battery?
Thanks
Alex
Evening all :-)
I am about to install a Ctek dc-dc charger in my van but would like the option of connecting a charger from the mains as well without frying the dc-dc charger or overloading the system. I cannot seem to find the answers anywhere despite searching everywhere, how have you guys...
Hello boys and girls
I'm intending to fit a CTEK D250SA to my T6 but I also want to permanently connect a 240v battery charger so that the leisure battery charges when hooked up to shore power. Can anyone see any potential problems with that
Thanks in advance
Hi everyone
Does anyone know anything about these CTek split chargers?
I've built my own campervan and read alot about T6s and their smart alternators etc. So I bought a CTek split charger and wired it all in.
It all works fine, the solar charges the new leasure battery and the alternator...
Anyone know how to make rear offside under indicator section hinged access panel to install electrics simulator to Jerber Campers hook up access .. I would like to install an additional 230v socket in there to power externally when on hook up ..typically small oven etc... but don't want to put...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.