DC27 is the correct battery for a twin seat.
That's great then as shey shouldn't interfear with heating ductThose looms go left and right to under the front seats, just out of shot.
That's great then as shey shouldn't interfear with heating duct
Why not consider fitting the intake and vent using oem factory parts. Air intake in the drivers step and the heater vents in the drivers side B pillar. Have a read through this thread. Fitting the OEM Auxillary Heating Ductwork
Yes, I have full furniture and Propex will be using the side step for the 'intake' (agreed the rear of the van wouldn't heat well if this were used for the outlet plus the outlet gets really hot - so I'm told).Dale, is that camper furniture in your avatar?
If so, an OEM heater duct fit-out might not be worth it if your furniture will block the airflow.
The step intake will still work - there’s the option of using that as your heater outlet, but then the back of the van won’t warm up as quickly.
If it is furniture you have, what have Propex said about routing the heater outlet up through the floor a bit further back, so it exits via the kick-boards beneath your cabinets?
And there’s definitely no room to bring it up beside the aux battery under your drivers’ seat?Yes, I have full furniture and Propex will be using the side step for the 'intake' (agreed the rear of the van wouldn't heat well if this were used for the outlet plus the outlet gets really hoy - so I'm told).
I will look again at the rib kickplate though I think there're other reasons why that won't work hence the proposed outlet coming through the floor as mentioned.
For sure it'd have been so much better if heating had ben installed at the time of the conversion or at least provision for it
Hi, no, the space under the seat is taken up with the 2nd battery and the back plate is fitted with a marine battery isolataion switch as well so under the seat is just not possibleAn
And there’s definitely no room to bring it up beside the aux battery under your drivers’ seat?
Just to confirm , a 110 AGM battery will not fit under passenger twin seat ? . That was my plan but will have to be fitted to rear is this correct .thanksDC27 is the correct battery for a twin seat.
No, the 110AGM is too long.
Like it.....