wiring

Hi all just fitted this wheel in place of my standard wheel how can i get buttons to work

Good evening all, I’m at the stage now where I’m thinking hard about wiring for my conversion and Routes to take to do certain supplies. I’m putting a leisure battery under one of the front seats amd will mount a fuse box in there too. Where do most people run their cables? Under the ply floor...

Hi all. I am currently converting a twin sliding door kombi. Does anyone see a problem with running a 240 cable and a positive feed under the ply floor to rear cupboards. I have the MCB under passenger seat and CTek with leisure battery under drivers seat.

Hi all, Do you all use conduit in your vans for wiring or just run direct / with wiring loom tape. I've seen lots of videos using miles of conduit, and whilst I can see the benefit in some situations in a T6 it seems to perhaps be overkill? I was planning on using some conduit ti run all...

Hi all I think I’ve read all the info on here there is to read several times. So either the info isn’t there, or I glazed over at the wrong time. Anyway, I’m about to do the MFSW with cruise on wheel mod to a van with no cruise to start with. Therefore, I need to run a cable from the T10 pin 1...

Third post today. Not quite sure about wiring in the Dometic fridge with my Sargent EC160. There appears to be a couple of ins for it on the Sargent. I work with properties and so am fairly ok with wiring etc. But, I'm not quite sure what I'm supposed to be doing with the fridge. I think the...

Hi, I fitted my towbar ages ago (easy bit!) and have just ordered the 13 pin Westfalia electrics kit to finish off the job. This is a two part kit - firstly, the main 13 pin loom and secondly, the separate ignition switched live loom for the 12v auxiliary (fridge etc in the trailer). This...

Hi there i have been reading the threads regarding folding mirror not working, i have tried some of the ideas but to no avail, i wondered where i can test to see if the motor in the near side has packed up or the wire/switch is the problem. The van is a t6 2017 and it has had a secondhand door...

Hi all So converting my T6 and and had an sca roof fitted, windows, carpet lining and I'm just about to fit Altro flooring on top of my 12mm ply floor. Was wondering if anyone can give advice on cable runs from front (under the drivers seat) to back (where the cupboards will be) I have a length...

Which wire is the best to get as I'm currently putting folding mirrors and need to make up a couple of cables. I have the correct connectors just wondered which sort everyone is using?‍♂️

Im new to the transporter world. Im looking for a location for my Leisure Battery and have looked under the Single front Passenger seat. The available pace looks ok. Easily 330 mm L x 230 mm H x 200 mm W. While looking I found a bunch of taped up (from Factory) Positive wires. One looks to...

I have had my T6.1 HL 150 DSG PV for a week now and love it. I have 2 Factory single swivel seats up front Here is a few pics of the space and wiring below each seat. and a pic of the Dash fuse panel If anyone wants and pics of any part of the 6.1 or info from the manual just ask.

Hi all, new on here and hoping for some help! Just started planning out my conversion and was thinking about the routing for the electrics and what order to do things.. I've sound proofed and insulated the walls, was thinking about doing the floor next. Do I need to get the electrics in first...

Hi, I’m about to pull the roof panels, pillar trims and bits of dash to run rear speaker wires, rear dashcam cable and 12v supply / earth for front dashcam. Route will be nearside under roof panel and down A pillar. I have already seen the air bag switch removal / ign on warning re air bag dash...

Diagrams, Schematics & Wires -- How I Done It -- ************************************************** Dellmassive`s -- "how I Done It" -- Thread ************************************************** Kit List And Stuff -- How I Done It & What I Use --...

From what I can find the 12v Dometic fridge draws 3.33Amps @ 12v, so around 40Watts. This will be the largest 12v draw on my leisure battery system, so 11Amp wire all round will suffice? (For everything, lights etc) I'm just about to purchase all the cabling, any suggestions? I was going to...

Do you guys run all the cables in conduit? Do they rattle? Is it a real necessity or personal preference? Has anyone run conduit with some string in it for running additional cables or replacing cables in the future?

Hello Fellow T6'ers!! I'm am almost at the stage in my conversion where I need to consider details within the electrical install. Being a complete novice, can anyone direct me to any good DIY guides, posts, YouTube vids, etc... Thanks in advance! Ian

Afternoon Team, I’m wanting to run 230vac & 12vdc cables for power sockets from under the passenger seat to the lower section of both the C Pillars and was wondering if anyone had any suggestions that’s not too gash or involves drilling holes. I’m not too keen on drilling holes or just running...

I want to feed some 12v cable from the leisure battery under the drivers seat to the small panel on the C pillar just behind the near side slider. I'm fine getting it into the roof but can not find the entrance at the top of the C pillar, or when I try to feed upwards the flexi tool Im using...