Hi, looking for recommendations for a leisure battery & Eberspacher heater installation in South Wales? I want the heater to be fitted as per factory, underfloor & blowing out of front step + B pillar. Anyone had this done & happy? TIA
Hello, please can anyone help me with details of what would be involved in fitting a secondhand Beach overhead Heater Control Unit (near the cab centre lighting) and Eberspacher night heater into my T6 Caravelle? Many thanks for any advice.
Hi everyone hope you can help! I installed a Chinese diesel heater under the drivers seat of my 2016 T6 last year and just ran it of a separate fuel tank. I wanting now to drop the fuel tank and connect it straight to the tank but was wondering where is the best place to drill for the fuel line...
Hi
My mate is desperate to get a diesel heater fitted the Eberspächer is his choice.
Anyone recommend a fitter who has them in stock. He’s in the Yorkshire area but will travel.
Thanks
Looking at fitting on rear panel on seat base the heater outlet but both supplied and various suppliers all seem to do similar.
Would like to keep these panels but only alternative position on drivers base is forward of handbrake on the side.....
After a decent condition oem diesel heater chassis bracket.
Dealer quoted me £110 but I thought id ask on here first before i willingly become a victim of daylight robbery.
Cheers
In relation to this:
https://www.t6forum.com/threads/genuine-california-webasto-diesel-parking-heater-vented-step-b-pillar-posts.31286/
does anyone know what controllers and other things I would need to get the heater working? Thanks
basically started accumulating parts a few years back to retro fit this to a panel van using genuine parts.
genuine Webasto air top. with bracket
drivers vented step ( cold air intake)
B pillar post with outlet vents
b pillar ducting
pretty much everything you need to retro fit the heater with...
I'm planning for the future when I get up to installing a heater.
As far as I can think there are 4 main choices, in the poll.
So I'm looking for recommendations. I wasnt to happy with the control module of the last one and would have likes a remote turn on, but it was rather expensive.
So...
I have a planar/Autoterm PU27 LED controller which I just used to test my heater when installed so still has the film etc on it and is essentially new. Good upgrade for anyone that has the standard basic controller.
these look to be about £85, anyone interested for £60 before I put it on eBay...
Hi Guys, just got a T6 camper 150 DSG……delighted with it so far.
It has a Webasto diesel heater fitted. I understand the heater air intake is through a circular vent in the driver’s side door step and the heater outlet is obvious behind the driver seat, but what is the purpose of the circular...
I decided to go for an autoterm diesel heater but wasn't looking forward to dropping the diesel tank. Someone suggested I could use a T-piece connected to the return pipe between the tank and adblue as the picture. It was so easy to fit the hardest part was attaching the rubber tube. Sofar...
Just wondering if anyone runs a separate tank (rather than connecting to the main fuel tank) for a diesel heater (ie. Eberspacher etc)?
If so where have you located the tank and any issues?
I'm wanting ro mount the heater in the factory position under chassis (drivers side).
Cheers!
Due to change in circumstances now looks like I have to fit a chinese diesel heater under drivers seat, only issue is seat base trims with footwell leds. I am struggling to find a 60mm ID vent that will squeeze in the 75mm recess.
Given that I ended up sitting in my pants in my van at 2am because my ( got to get this right ) Airtronic S2 D2L decided to go into full blast mode as the outside temperature had dropped below 5 degrees - What heating system would you recommend ?
( I can’t got through a winter in my pants at...
Looking at fitting one of the chinese heaters but dont want hassle of dropping tank for now. Has anyone located the supplied tank out of the way, need something for wild camping over next bank holiday weekend, I know its hassle filling up but wonder if it will fit inside spare wheel itself or...
Hi Guys,
Had an autoterm/planar heater installed and at the time the guy didnt have any angled vents to push the air around our kitchen unit. I've brought one which i actually think is a wrong one. But I cant get the current one off and didnt want to brute force it incase i broke it.
How do...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.