renogy

So the renogy DC to DC with built in mppt is quite a bit cheaper than the ctek but is it as good ?

I contacted Renogy to see if the DCC50S is compatible with a mains battery charger (which I already have installed - looking to add the DCC50S + solar panel) I got this response: The DCC50S won't be able to detect if a battery is also being charged through another source hence we don't...

Due to a change of plans I no longer require my Renogy Bluetooth communication hub,I have opened up the mounting holes see photos See full details here - Bluetooth Communication Hub for BT-2 Bluetooth Module £25 posted UK mainland

Hello. I’ve got the Renogy Battery Monitor attached to a LB with 95Ah capacity. Set up of the monitor includes manually setting the Ah capacity of the battery directly as a value. I had put in 95Ah. I read the manual again and it says to set this value to the ‘usable capacity’ - so should this...

I now have a Renogy 100Ah Lipo battery and 50A DC-DC charger to fit to my van. I'm thinking of adding a Renogy 1000w inverter to the system but the ones shown on the UK site don't have a RS485 comms. If I look at the Renogy inverters for other countries they all have a new version out with the...

Hi all, I’ve read as much as I can find relevant to this problem and hoping for some expert advice. I’ve purchased a 500A Renogy Battery Monitor (I think you are all familiar). The installation is simple enough, except the bolts on the shunt are 10mm and all my accessories (negative terminal...

Has anyone had a problem pairing a Renogy BT-2 bluetooth device to an Android phone. I’ve just installed and connected their 50a DC-DC charger and MPPT controller. It powers up ok and I’ve downloaded the app but it cuts off and closes down a couple of seconds after opening. The app stays open if...

Hi all, Been a while since I've been on here. Just throwing something up to say I've finally got together a Python driver to pull stats from a Renogy DCC50S using a USB modbus adapter/dongle plugged into a Raspberry Pi. The python module is fairly modular so just pulls from the dongle and spits...

Wanted a leisure batteary but didn’t want it under the front seats so made this to fit under the right hand side rear seat of a Kombi. Also includes a Midi\Maxi fuse box and a Renogy DC DC charger. Vanarchy Newquay done a great job carpeting before it gets installed. Was not able to find...

I just posted this on the wrong thread...:( Just when I thought I had cracked the “which solar panels” question another potential problem comes up. For me, height is critical so I can’t have anything more than 2cms above the roof. I want 200w of solar power up there and 2x100w panels would be...

Battery in a box

Hi All, First post so please go easy. I have searched the forum but I haven't found any other posts on this. I fitted my CTEK 250SE DC to DC charger around 2 months ago and all was working as expected , I would start the engine and after a few seconds the CTEK would start up and charge the...

I have noticed that a few people have now fitted Renogy products. As I have been offered dealership on this stuff I would like to gain some feedback on it. What do you all think of it? Would you buy it again or buy further products from their range based on the general build quality?

I have a general build thread in the works (Our T6 build journey...complete beginners!) but starting a separate thread for the electrics so that people can tell me in one place if i'm going to set my van on fire. After much research and deliberation we decided to go the lithium route with our...

Hello I’ve been running one of these for the past month with no issues been doing it’s job fine Had a look today and it seems to have stopped charging,no light on for the solar or the alternator but the voltage is reaching the unit ok 19v on the solar at the renogy and 14. odd from the...

There is currently no display available for this renogy B2B. So if anyone is interested, I've made one........... The RS485 port is Modbus RTU and Renogy gave me a datasheet showing where all the data lives Arduino boards have serial comms built in, and just need a RS485 module adding and then a...

Has anyone got any reviews on renogy solar panels? Looking at this: 160 Watt 12 Volt Flexible Monocrystalline Solar Panel Voc is 23v so bang on the limit of my ctek d250sa. Just wondering about build quality etc of the renogy? Cheers Bob

Does anyone know where I can get this? Is it the same as the T6?

Has anyone fitted one of the Renology DC-DC battery chargers? I believe this is all I need for regulate charging from the alternator and solar panels? The only thing I can't ascertain is the option to output the data to a compatible display module/ iPhone app...

RENOGY release DC-DC 20/40A charger! . . . . . . . . . . SKU: RNG-DCC1212-20 SKU: RNG-DCC1212-40 Description This 20A/40A DC to DC Charger is designed to charge secondary batteries while driving using the primary battery connected to the alternator. It is able to charge: Flooded, Gel, AGM...