passenger lowered seat base I am having these made in the UK they have a locking door at the rear to hide away from prying eyes as you can see in the pictures it can also hideaway with the trim panel as the lock has a low profile. they are slightly narrower than some seat bases thus allowing...
hi
i am installing a swivel to our front double passenger seat - does anyone know of secure smallish safe which would work or is it only possible to put it under the drivers seat but this is where the heater exit is going to be placed.
any advice welcomed
Does anyone know the measurements of the drivers and passenger seat bases?
I have found posts on this forum which say what battery/kit they've fitted but can't find the actual dimensions published anywhere.
I have a 4 motion panel van on order with two single seats with factory swivels and I...
So annoyed with myself. Rejigged all the electrics under the drivers seat. Put the drivers seat back on and the 2 wires out the top of the ctek foul a bar under the seat.
Any thoughts as to cutting away the insulation on the ctek sense wires and making god with hot glue or do I need to move the...
Just finished installing the ctek and battery etc.
I thought it would be easy to make it look neat. With loads of room.
Nope. Awkward af.
And advice on how to tidy up this nest of cables?
Thanks
Hi All.
I was wondering if its very bad practice to place the inverter under the driver seat? I don't know if theres room yet. I have a battery, fusebox and ctek 250se.
Or would it be best placed under my passenger seats? I have a double.
Im only looking at a small inverter to run a laptop...
Hi all ,
I am fitting a diesal heater to my T6 campervan and want to remove the front passenger seat. Should I disconnect the battery before unplugging under seat connectors as I have a side airbag in the seat and dont want to set it off .
Drivers seat base with lowered handbrake bracket to clear RIB seat swivels without spacers. (Might fit other swivels but not tested)
The handbrake bracket has been drilled off and rewelded about 25mm lower than standard. This clears the RIB swivel seat with a standard cover fitted and keeps the...
Trying to hardwire my Blackvue battery that is under passenger seat.
I got positive supply from fuse box. And found a suitable earthing point on the seat base.
It has continuity to earth. i.e I am find it with a multi meter in any metal part.
But I am not getting a power feed due to no 12...
I have a general build thread in the works (Our T6 build journey...complete beginners!) but starting a separate thread for the electrics so that people can tell me in one place if i'm going to set my van on fire.
After much research and deliberation we decided to go the lithium route with our...
Has anyone had the weld for the nut under the drivers seat that connects it to the black base come loose? I am trying to loosen the bolt to get the top of the seat off but it just keeps spinning and I can't get in to get a decent hold on it to sort it. Any thoughts?? :(
A pair of VW single seat base plastic covers.
Came off my Kombi when I converted to a camper.
£10 for the pair.
I'm near Sevenoaks in Kent, collection please.
Having a clear out of my garage.
Original VW single passenger seat base. £20.
I'm in Kent near Sevenoaks J5 on M25.
Collection only as would be a pig to package up and post.
£20.00
Does anyone know if there is anyway of making the driver seat slide back further than the standard limits.
is there any mods than can be done or alternatives parts that can be fitted.
only need it to move back a few more inches.
Have anyone fitted/ have experience of using this sliding double seat base?
I'm keeping the double chair setup for the moment, and like the idea of being able to bring another two seats closer to the table, if you need to be inside, (cold/ wet/ playing cards etc...).
Hi I've bought this battery GB12115 - Battery Service Hub
But I've been told it wont fit? Is there any way i could make it
Dimensions
length 331 x width 176 x height 220 mm
Morning!
Installed my leisure battery under my seat with a split charging system (CTEK) other than those items with an isolation switch (accessible from the under the front of the seat) there is not much room for anything else, so far so good.
I need to bring that power out and will distribute...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.