Reversing Camera - Lowline to Highline Upgrade/Retrofit

Hello, iam new here.

I have a t6.1 and will retrofit a rearview camera.

I have this Camera 5Q0980568B

After flash Firmware and parameter file with Odis e I have coding with 000000… and can’t coding the camera.

Maybe someone can help me? I do something wrong?

This files
FL_5Q0980568A__0180.frf
6C_5Q0980568B-GOLF7.xml
 
Hello, iam new here.

I have a t6.1 and will retrofit a rearview camera.

I have this Camera 5Q0980568B

After flash Firmware and parameter file with Odis e I have coding with 000000… and can’t coding the camera.

Maybe someone can help me? I do something wrong?

This files
FL_5Q0980568A__0180.frf
6C_5Q0980568B-GOLF7.xml
The encoding of the camera must fully match the data set!
I tried many different datasets and the coding was different for each of them!
 
The encoding of the camera must fully match the data set!
I tried many different datasets and the coding was different for each of them!
Ok, thank you for information.

Maybe you can send me your files?
Or do you know where I can download it?
 
Hello Robert,

in your video I see you can choose on the right side different views.

View attachment 223740

I also made this retrofit but I have no selection there.
I can only get the camera screen working on the radio if I check in Byte 19 bit 4. I think the radio handels it like a lowline camera, therefore no views selections are possible.
The guidelines are working.
If I disable Byte 19 bit 4 and enable ENG122229-ENG117712-Car_Function_List_BAP_Gen2-VPS_0x0B the radio don´t switch to the camerea screen either pdc screen.
ENG122229-ENG117713-Car_Function_List_BAP_Gen2-VPS_0x0B_msg_bus ist set to "Infotainment databus".

Once I made an update on my radio to a newer SW Version. Since that I have the error in 5F, but everything is working. I don´t know if the SW Version is the error or my coding/adaptation.

Here is my actual scan:




Can you help me what the right coding should be to use the camera like a highline camera?

I also hope with highline configuration I can activate the camera with the PDC Button, because I want to add a front camera. But with lowline configuration the camera screen is only visible in reverse gear. Not very useful for a front camera.

Thanks in advance
I have the same situation. Have you managed to resolve it? What were the final adaptations and settings? Thank you in advance!
 
My experiences tell me that I need to turn off the low camera and activate the BAP protocol.
Thank you! You are spot on. Final settings in my case :
ENG122229-ENG117712-Car_Function_List_BAP_Gen2-VPS_0x0B = Activated

ENG122227-ENG117496-Car_Function_Adaptations_Gen2-menu_display_pdc = Activated

ENG122229-ENG117713-Car_Function_List_BAP_Gen2-VPS_0x0B_msg_bus = Infotainment data bus

byte 19 bit 4 = Disabled
 
Back
Top