dash

Why is the front edge of the centre dash tray removable? Is there alternatives ?

Ok, moving forward with my passenger bench seat install.... The single passenger seat indeed does have a different dashboard airbag to a bench. I've sourced the correct one but my next question is how to get to it. Spent ages googling and searching forums but cannot seem to find any information...

My new van arrived yesterday so while I waited I’d already bought a set and painted them so these are for sale. Just swapped them out today. All in perfect condition ready for someone else to perhaps do the same. Makes a really nice difference to the cab. Looking for £100

I'm swapping my (single) passenger seat to a bench and I understand the dash airbags are different in size. I'm after 7E2880202D. Is anyone out there doing the reverse conversion and needs the single airbag?

Fitted the Van-X Comfort dash but wanted to extend it right across the dash, to include the screen surround, the centre panel surround and the instrument binnacle. Stripped the parts out and had them hydro dipped. Really pleased with the result which gives a full flow of gloss black across the...

Greetings. How do I remove these two pockets? Do I just pop them out with trim removal tool? Trying to sort a couple of rattles. Thanks.

Hello. First question on the forum from a new member. My 2016 T6 LWB doesn’t have a top tray 12v but does have a blanking plug. I bought an OEM socket and cables from a breakers that’s exactly for this vehicle. I’m going to wire it in to the ignition-on 12v supply using a piggyback. I’m aware...

does anybody else have a rattle in the dash over rough ground, its the top section that has in the middle where it seems to be coming from.

Hi, I’ve taken my lower dash in my t6 to bits to run some cables for rear speakers etc, I’ve come to put it back together again and for the life of me can’t figure out where this but came from, any ideas please?

Hello this is my first thread asking for some help along the way please guys gals I’m doing something that I’m not sure if someone’s already done or not i have a 2008 T5 2.5 swapping the interior dash out, crash bar, steering column, heater blower/heater matrix/ aircon unit, door cards and...

Help, I have an annoying rattle under the dash cup holder. I thought it would just pop out but apparently not ! Does anyone know how to remove the cup holders on a T6 dash?

I’m trying to remove the glovebox from my T6.1 Kombi Startline for a leisure battery charge cable. I can remove the passenger dash side panel (with the airbag switch) and three screws below the glovebox, but now I’m stuck. I can’t see any other screws and nothing else is obviously budging when...

Hi all A couple of days ago I noticed my rear diff and seat belt warning light come on at the same time. I’m not quite sure about the rear diff light but the seat belt light was dim. I was wearing my seat belt and when I unplugged it the seat belt light illuminated double the brightness. But...

Depending on what options you have and whether you have a factory second battery etc. the top dash fuse can be in different locations. This first location is below the centre socket by the tray is highlighted below. The empty slot just below it is one of the Top Dash socket fuse locations...

Hi Over the last few weeks this rattle is getting worse. Iv checked under bonnet like some past posts have said but I have no idea with out taking dash out what it may be. Has anyone else had a similar noise?? It’s a taping noise seems to be from centre of dash Iv recorded it but unable to...

Checking out the wiring in my 2017 Highline and discovered the harness for a dash USB port, a purple plug. Question is which fuse should it be wired to in the fuse box ? The plug reads no voltage including when the engine ignition switch is on. Also the original head unit has been replaced...

Hello, do Someone have on this forum experience with wrapping off the dashboard? I won to wrap mine and want some tips and tricks? also one to know with part of the dashboard you can wrap

Hi all Started removing my dash so i can repair heater,I've removed all the lower trims,glovebox,radio,heater controls,clocks is there any hidden fixings i need to be aware of,or a guide on removal,need it done for sunday

I have just installed a VanX glove box and managed to snap a clip on the dash vent in the process. Has anyone swapped their vents for the vanx ones or similar and have the originals no longer needed. Happy to pay a fair price.. Mine still fits but its really loose now and bugging me...

Hi... trying to find a company that can match the front cab interior to the conversion colours. Ideally want them to put new entertainment system/sat Nav etc and speakers through to back of van too. Picture is of current conversion. Any pointers appreciated and first post on T6 Forum