For Sale Standalone ESP32 BLE Battery Display for Victron Systems

[RicoPicoUK]

Thats it folks, sold out of the screens. As I say, more is coming

 

[RicoPicoUK]

More screens are going to be added to the store at 1700 HRS BST today 17/07/2026.

I think the next delivery will be in a week after today.

All orders from yesterday were posted this morning.

 

[jumans]

Also do you have the STL File I could have for this one please?

Yes this is what I am after

 

[Daz395]

I can't remember where I saw it but somebody used a magnetic phone mount and their vehicle

Temporary but stuck a washer on the back with double sided tape then attached to my phone mount. Plan to hard wire soon.

 

[TheodoreThomas]

That's it!

 

[The3Ps]

Here my idea of fitting to the car but keeping the screen removable it also doubles up as a phone holder, win win
Only £10 from Amazon

 

[TheodoreThomas]

This is what I'm using on the USB A port on my 12 volt power port in my camper. It's a cord and mount all in on. I don't have a picture of it installed, but it works perfect. They are on Amazon

 

[B3N]

Well done and thank you Gary - this is genius!
Small magnetic mount from Amazon… absolute doddle to set up (once you realise you need to turn off demo mode! !!)

 

[DWiskow]

ChargeScreen fitted with the 3D Printed Case and Rear Power Cable. 12V DC was picked up from behind the USB socket with “T Tap Wire Connectors“ making the whole thing quick, neat and easy to install . . . the 3D printed cases are now available from https://chargescreen.myshopify.com/ when you order your ChargeScreen and Rear Power Cable.

 

[TheodoreThomas]

View attachment 332739

ChargeScreen fitted with the 3D Printed Case and Rear Power Cable. 12V DC was picked up from behind the USB socket with “T Tap Wire Connectors“ making the whole thing quick, neat and easy to install . . . the 3D printed cases are now available from https://chargescreen.myshopify.com/ when you order your ChargeScreen and Rear Power Cable.

View attachment 332740

Why not just use the case it came with?

 

[B3N]

It doesn’t come with a case - that 3D printed one looks a neat solution if using the rear power cable option
No case needed if using usb-c as can put a magnet on the back

 

[DWiskow]

Why not just use the case it came with?

You can, of course just stick the ChargeScreen to a panel, but then you have to find a way to attach it and work out how/where to drill a hole that lines up with the power connector.

Using the 3D Printed Mount addresses all those challenges and provides:

• Countersunk holes to screw to a panel
• A recessed channel into which to route the power wires
• Easy access with the supplied PowerKey to switch on ChargeScreen
• Ability to easily remove/replace the ChargeScreen if necessary (friction fit into the mount)

Ultimately, it depends on how permanent, neat and tidy you want your ChargeScreen installation to be when opting for the 12V DC powered solution (rather than USB powered) with no visible cable.