Stance+ Coilover Drop Confusion

[VwClarky]

How much travel have you got left on the fronts / used on the rears?
And is your van empty / a day van / a camper conversion?

It does look lower at the front than yesterday morning to be honest? Unless it’s the placebo effect?!

 

[Dan Lewis]

Hi,

I have stance coilovers, I’m maxed out on rear and you can remove the adjuster completely. If you go to transporter HQ website they sell a rear adjuster delete kit which is a plastic housing to sit where the adjuster was so it’s not metal on metal against the spring and van this will allow the full drop and no risk of knocking

 

[CRS Performance]

Please tell me that front tyre Touches ??

 

[Kernow Freeze]

Can people recommend Stance coil overs then?

 

[T6ARF]

Can people recommend Stance coil overs then?

I’d recommend going/speaking to a suspension specialist @CRS Performance

 

[CRS Performance]

Stance is the cheaper end of the market and this is evident in the quality of materials and design , The most important difference is the damping rates and valve design
you will find some people like them and many dont rate then. You do get what you pay for in this industry and a 500 quid kit will never perform or last like a big name kit

 

[t33]

Hi,

I have stance coilovers, I’m maxed out on rear and you can remove the adjuster completely. If you go to transporter HQ website they sell a rear adjuster delete kit which is a plastic housing to sit where the adjuster was so it’s not metal on metal against the spring and van this will allow the full drop and no risk of knocking View attachment 80878

Is Ur van all the way maxed out front and rear on the coil overs? What size wheel and tires do you run does it catch?

 

[Frigo110]

Is Ur van all the way maxed out front and rear on the coil overs? What size wheel and tires do you run does it catch?

Not sure you will get a response.

 

[Adssusie1977]

From looking at the rear close I recon the rears arnt full wound up and there 5-10 thread left on there

Hi,

Iv just recently started my T6 Project and was quite keen to sort out those nasty gaps in the wheel arches so bought some stance coilovers to try out.

They are advertised as Front Lowering: 30-65mm and Rear Lowering: 30-75mm

I haven't had time to do them so left it in the hands of the garage. As you can see from pictures the wheel arch gaps are still there. They said its on the lowest setting on the rear but i still have a lot left on the front and as advertised the rear should be able to go lower than the front so im a little confused as to why the rear is so high.

any help much appreciated.

Van

• ozhushion
• 20 Jun 2019
• 17” stance+ steelies weller wheels

Front

• ozhushion
• 20 Jun 2019
• 17” stance+ steelies weller wheels

Front Coil

• ozhushion
• 20 Jun 2019
• coilovers stance+

Rear

• ozhushion
• 20 Jun 2019
• 17” stance+ steelies weller wheels

Rear Coil

• ozhushion
• 20 Jun 2019
• coilovers stance+

U haven’t cut bump stops down or removed adjusters and replaced with adjuster delete Iv got same on mine and it sits pretty low

 

[Adssusie1977]

U can buy a delete for the rear and a machined top mount for front

 

[Adssusie1977]

U need to remove rubber and trim around 3/4 of inch off metal sleeve and add adjuster delete from transporter hq also look on there web site they do a couple of trick bits to drop it more