Rear Bumper Insert.

Big Zak

Member
VIP Member
hello all, could someone please advise me of the part numbers for the rear bumper insert on a 2017 T6.

I got a towbar fitted and my bumper is sagging in the middle and have been told that I need to buy the insert, to stop this. I am having problems finding one as I was told Part Number 7H0 807 723 was the one I needed, but it is for a T5.1 ? Is there no difference and what is involved to get it in place?
Cheers
Zak
 

Ayjay

Senior Member
VIP Member
T6 Guru
Sorry, I can’t answer the question but shouldn’t it have been part of the process of fitting the towbar and therefore down to the fitters to sort it out?
 

Ayjay

Senior Member
VIP Member
T6 Guru
In that case, they should probably be named so that nobody else on the forum has work done by them and has the same issue as a result.
 

Eli1264

Senior Member
VIP Member
T6 Guru
In that case, they should probably be named so that nobody else on the forum has work done by them and has the same issue as a result.
I’ve had towbars recently fitted to my Cali and me Velle before that. They came to my work both times, they fit a foam strip that sit along the top of the actual bar left to right before the bumper goes back on. Looks factory again
 

Paynewright

Senior Member
VIP Member
T6 Guru
Was it a van or kombi / passenger carrier? If its a van there may be a closing panel missing too. Some informative threads in the archives if you use the search.

That part looks the right one - I’ll be buying two this week for mine. Expensive bits of polystyrene!!

Ian
 
Top