Pic Needed Of Boost Pressure Sensor Wiring...

[Urban Andy]

Hi folks hoping that some kind T6 owner can help me out... Im sorting my van for conversion which was in a front end smash and is more or less sorted but im having a problem with the boost pressure sensor wiring, 3 wires going into a 4 pin plug as seen in the pics where all damaged... Im needing to find out which colour the wiring is to each pin on the plug... The van is a VW T6 2.0 tdi 2018 model...

Im just needing a picture of the sensor and the plug going into it... I beleive its a bit difficult to get into behind the radiator but no need to take it off as theres enough room to see it and get a pic..

If anyone can assist this would be so awsome as this little bugger is holding me up no end!

Much obliged
Andy

 

[Pauly]

If its the 'charge pressure sender' then
1 = brown/yellow
2 = empty
3 = white/yellow
4 = green/purple

 

[Urban Andy]

If its the 'charge pressure sender' then
1 = brown/yellow
2 = empty
3 = white/yellow
4 = green/purple

Thanks for reply Pauly... I'm not entirely sure on that one as it's a friend who's fixing it but I'll find out... however do you have the schematics for this particular sensor/wiring scheme I could see?....