Nice gap down the middle for cabin crew to dispense refreshments (or discipline) 
Kombi Seat Configurations
- Thread starter Semisonic
- Start date
Or for the giant teenager to stretch his legs.
Actually thinking about building a little table that fits over the back of the middle middle row seat, so that they can have cupholders etc in the back.
Actually thinking about building a little table that fits over the back of the middle middle row seat, so that they can have cupholders etc in the back.
yes I have done it
Well worth dropping in the extra brackets on the back row, gives great flexibility for longer loads and seating!
I like that, but I think I'm done 'investing' in seats for now. Next up is to design the bed frame that will fit over the top of all this.
were there markings / divots in the floor pan for R3 brackets?
As per Griff's post on page 1, you may need to remove some plastic covers from the side of the seat frame to get it to fit alongside the wheel arch, and cut the plastic around the middle anchor point, but otherwise it should be pretty straightforward.
This is the question I was going to ask.
Looking at the pics in this thread and others that show the heater trim then it may be a case of cutting out a section for the feet.
Be nice if someone has twin middle seats or the double in the 3rd row with a the heater in there too...
Does anyone know if you can put the single from a 2+1 in the 3rd row? I already have 3rd row seat belts for moving the triple back. Usually people just buy the central single shuttle seat and put it in the centre but the prices of those have gone silly!!
as in this pic below, can I put brackets where I've marked it up red and put the single from a 2+1 there?? as I have found some cheap T5 ones on ebay.
Thanks!
as in this pic below, can I put brackets where I've marked it up red and put the single from a 2+1 there?? as I have found some cheap T5 ones on ebay.
Thanks!
Won’t fit without lots of plastic panel hacking even on a LWB.
yes I think your right. My thought was that the single with the belt fits at the side but it doesn't have an overhang towards the edge of the van.
Thank you!
That won’t work - I mean anything is possible but this won’t be with factory mount settings, and a lot of messing around etc. The only seats that fit there are the centre seat from a shuttle- a conversion we have done lots.
Sorry to jump on an thread
@BognorMotors oli, does a triple bench fit or can or will fit behind the 2+1 factory kombi seats?
Cheers
Yes. There are the dimples in the floor for a triple
