Fuel Gauge Not Working And Component Protection.

[Jimmy-s3]

 

[Jimmy-s3]

Linked into the earth coming through the cab floor, then ran a new earth of the same diameter to an existing earth point under the plastic cover below the gear selector.

 

[Jammy420]

Linked into the earth coming through the cab floor, then ran a new earth of the same diameter to an existing earth point under the plastic cover below the gear selector.

Hi I'm having the exact same issue. Can you tell me where the bad earth is connecting to the body please? Is the 410 loom just a small one that connects the main loom to the sender and temp sensor?

 

[Jayt6moneypit]

Hey can anyone help I have this same issue
I found the red block under seat but wires are a different colour

 

[Robert]

Make sure the vehicle battery is fully charged, most erroneous CP problems are caused by low voltage

32 ignition cycles(ON/OFF) in a row will trigger CP as well.

 

[Robert]

32 ignition cycles(ON/OFF) in a row will trigger CP as well.

This video shows how the counter actually works.
Basically if there is a break in the ignition cycling, long enough, the counter resets itself to 0.

 

[Cbeattie51p]

Hi I'm having the exact same issue. Can you tell me where the bad earth is connecting to the body please? Is the 410 loom just a small one that connects the main loom to the sender and temp sensor?

we have the same issue, did you resolve it? There is no red block with the purple/black and brown/white gauge wiring under the passenger seat