CXEB… I think you know where this is going..

Lavo

New Member
Well after being concerned about oil consumption over the last few weeks. I’ve been weighing up new engine options and all that fun stuff.
Now i’m not 100% certain but I think its done 500ml in 500miles. Topped up and logged milage to monitor again.
Fast forward to last night and my EML makes an appearance with the flashing glow plug light and reduced power.
Multiple plausibility/ range/ performance faults stored. Sensor ref B voltage. Along with P13D500 (Glow plug cylinder 3 pressure sensor) My thinking is the glow plug sensor has pulled the circuit down.. thoughts? anyway I digress…
Seeing I was going to effort of replacing the glow plugs I decided to do a compression test. When in Rome and all that.
All cylinders were 22/23 bar. No excessive oil in the inlet/ cooler/ Hoses. So i’m a bit stumped. IF its consuming too much oil is the block wearing and its just about what VW would call ‘normal’
Or do I pull the turbos? Is there something i’m missing? I expected to find something obvious.

I might borescope the cylinders before it goes back together. But if all good, then what? 🤔

CXEB 204 MY19 LWB 4MOTION
 
  • Sad
Reactions: CAB
CXEB 204 MY19
Based on VW TPI MY19 is not a primary candidate for block wear type of oil consumption issue.


1771225877546.webp
 
More cxeb info.


 
Quick update: it’s not looking good.. quoted for a new engine. Looking at least 6k. No labour.
I’m planing on taking the cylinder head off before pulling the trigger to try and get a better understanding of whats happened.

Still, better now than somewhere in Europe.. I guess 😅

IMG_3604.webp

IMG_3603.webp
 
  • Sad
Reactions: CAB
When you follow the VW TPI,

After the oil loss test .....

The first test is the cylinders compression test.... Which we have the lower limit now

And then after that to measure the physical bore wear, to confirm the wear...

That then proves the problem.

Fix is long block engine + car + DPF + lambda sensor.
 
FYI..

compression test . . .


new engine 25 - 31bar
wear limit 19bar
max difference 5bar


.....


Screenshot_20260224_184659_Chrome.webp
 
Why are you stumped?
You have performed a compression test on all cylinders which is satisfactory.

You have checked boost pipework for excessive oil and that is also satisfactory.

You have a fault codes that you are yet to action for a glow plug.

Yet you are looking for a new engine and taking the cylinder head off ??

Why not replace the number 3 glow plug or sensor ( for the code ) first?
 
Compression test was 22/23bar all cylinders. I was hoping the compression test would nail something on straight away
Why are you stumped?
You have performed a compression test on all cylinders which is satisfactory.

You have checked boost pipework for excessive oil and that is also satisfactory.

You have a fault codes that you are yet to action for a glow plug.

Yet you are looking for a new engine and taking the cylinder head off ??

Why not replace the number 3 glow plug or sensor ( for the code ) first?
Because its failed an oil consumption test. And further investigation has found some worrying signs on the bore (cyl 3)
FYI..

compression test . . .


new engine 25 - 31bar
wear limit 19bar
max difference 5bar


.....


View attachment 317726
Thanks for the data 👍🏼
 
Why are you stumped?
You have performed a compression test on all cylinders which is satisfactory.

You have checked boost pipework for excessive oil and that is also satisfactory.

You have a fault codes that you are yet to action for a glow plug.

Yet you are looking for a new engine and taking the cylinder head off ??

Why not replace the number 3 glow plug or sensor ( for the code ) first?
The glow plug/ sensor fault is a separate electrical issue.
Believe me i’m not taking the cylinder head off for a laugh. I’d just rather pull the head now and confirm my worries. Replace the engine. Can’t have it 💩itself in the summer when i’m Europe.
 
Last edited:
Fyi....

For the VW 2.0 BiTDI (CXEB) engine, Volkswagen typically considers oil consumption up to 0.5 liters per 1,000 km/621miles (approx. 0.5 quarts per 621 miles) as within acceptable limits, according to technical bulletins. However, many owners and specialists consider anything approaching 1 liter per 1,000 miles to be excessively high, potentially indicating premature engine wear, particularly EGR-related cylinder damage or turbo issues.
 
How are you monitoring the oil use,?

VW do an oil weight test ... As oil dilution from diesel can show incorrect data.

IE a clogged dpf will cause excessive regens that cause diesel to get in the oil and raise the level etc.

Oil is heavier than diesel, so they add a specified amount of oil and weigh it. Then you do the 620 miles,.... Then they drain and weigh it.

The volume may be high, but the weight low.....indicating oil dilution. And a high oil loss.
 
Back
Top