What Have You Done To Your Van Today?

@Vedubber. I put some of those on our acapulco blue T6 not long after we bought it. When they first went on, I wasn't sure about the look so I left them for a couple more weeks but still wasn't convinced so they came off and went in the bin.
The worst bit is they don’t fit very well either. They are different side to side and I still needed to trim them. They were free so not fussed if they do end up coming off.
 
I used a wire wheel on the drill and then scotchbrite and autosol on mine , came up like new ;).
We have a none resonated milltek on ours, had to turn the tailpipe sideways cuz it looked like it hung too low for my liking.
20250224_154108.webp
 
Ooooo I used a scotch pad on the drill and some barkeepers friend. Going to have another stab next weekend to try and get the worse of the spots out. Need to grab some wd40 to loosen the bolts on the lwb extension too.
 
Test fitted some L track and fork mount for the bike.

Just waiting on some hardware to bolt it down and going to design and 3d print some end caps.

View attachment 316178

The original bolts don't reach the nuts so are there to stop it sliding about when I fitted the bike

View attachment 316179
I may steal this idea as I need to be able to transport a bike and dont want an external carrier. I was also considering trying to attach a fold down wall mount bike clamp/work stand to the inside of the barn door if I can get a spreader pad into a suitable area to take the load and can be used when the doors are open for any maintenance
 
Last edited:
Back
Top