[T6_measured] 01-Engine - Oil pressure switches & Oil level sensor

[rudzionek26]

I think two sensors are going crazy, one green and one brown, because two of them are open or jumping all the time, and the pump is pumping at 100%.

 

[rudzionek26]

Myślę, że dwa czujniki szaleją, jeden zielony i jeden brązowy, ponieważ dwa z nich są cały czas otwarte lub skaczą, a pompa pompuje z wydajnością 100%.

 

[rudzionek26]

I'm in the coil light fault code 16056 spin cycle. Been around the houses now, high and low switches replaced twice, regulation valve , finally mechanics replaced the oil pump. There were fragments of aluminium in the strainer, took the old pump home and dismantled it, very worn surfaces, perhaps letting oil pass? Also small gouge on a port. Doesn't look healthy so glad to have replaced it. The wear looks like it should have a bearing at that point, rotating part wearing straight on the housing. Hope this is the fix! Thanks to VeeW services for the very quick turnaround for our holiday

View attachment 250921

View attachment 250922

View attachment 250923

View attachment 250924

View attachment 250925

View attachment 250926

Hello, I see you've disassembled the oil pump. I found this part in my oil pan, and I'm not sure if it's from the oil pump. Do you remember if there was something like this in the oil pump?

 

[rudzionek26]

Removing this sensor is not that easy

 

[rudzionek26]

I replaced two valve sensors and I still have error P0164d, I don't know what to do?