nice - which make of pop top did you go with? cheersPop top installed! Very happy with the result - cracking people & competitive price. Shame I had to sell the Z1000SW to pay for it
View attachment 190436
ToddiesT6 - Build Log
- Thread starter ToddiesT6
- Start date
-
- Tags
- build thread.
Final “10 jobs” to get T6 sorted before I chance my arm with the DVLA reclassification! But now I just need some free time to do so!
1) fit the sink drain pipe & outlet bracket.
2) mount the water cylinder straps.
3) wire up the tap switch
4) make the single piece worktop + carbon finish
5) buy & fit the induction hob
6) buy & fit side graphics.
7) sort out the NSR spoiler (around carrier)
8) sort under bed seat storage solution.
9) build the occasionally slider table
10) fit a side spin out table on the B pillar.
But I’m very happy with my big FOC sheet of carbon twill!
It’s good being a composite engineer at times & a very good excuse to donate to ‘help for hero’s’
1) fit the sink drain pipe & outlet bracket.
2) mount the water cylinder straps.
3) wire up the tap switch
4) make the single piece worktop + carbon finish
5) buy & fit the induction hob
6) buy & fit side graphics.
7) sort out the NSR spoiler (around carrier)
8) sort under bed seat storage solution.
9) build the occasionally slider table
10) fit a side spin out table on the B pillar.
But I’m very happy with my big FOC sheet of carbon twill!
It’s good being a composite engineer at times & a very good excuse to donate to ‘help for hero’s’
Well the carbon fibre skinned worktop complete & installed. Should have infused the log slices over routing & filling, but I still like the customised look.
Likewise the sink’s installed & wired in. With a 15lts container hidden behind the fridge as space is precious!
Later this weekend it’s time for the final tabour door to cover the electrical install & the induction hob also
Slowly slowly the final jobs are being ticked off ready for the 1year anniversary trip to Scotland and the NC500.
Likewise the sink’s installed & wired in. With a 15lts container hidden behind the fridge as space is precious!
Later this weekend it’s time for the final tabour door to cover the electrical install & the induction hob also
Slowly slowly the final jobs are being ticked off ready for the 1year anniversary trip to Scotland and the NC500.
Cracking little induction jobs available online these days & so that’s the cooking arrangements taken care off.
Prefer gas, but utilisation of the LiFePO4’s I ended up with [for the worlds (my) most expensive coffee machine] influenced my decision, that and the number of horror story’s I’ve been reading.
Prefer gas, but utilisation of the LiFePO4’s I ended up with [for the worlds (my) most expensive coffee machine] influenced my decision, that and the number of horror story’s I’ve been reading.
Rear cupboard gets a much needed top panel - as that’s yet another finishing job I’ve been meaning to tick off.
Likewise the tables made, storage affixed to the rear barn door storage and this too gets a carbon fibre skin - but not till after the NC500.
Likewise the tables made, storage affixed to the rear barn door storage and this too gets a carbon fibre skin - but not till after the NC500.
Nice
