T6.1 foglight coding in adaptations

Christoft6.1

New Member
VIP Member
Hi all,
I'm wiring foglights to a 2020 t6.1. I have fitted the lights and fitted the wires to pins, 3&40 on the bcm. I have gone into adaptations and I'm not sure what to do now. Any help would be greatly appreciated.
I fitted a new switch with a front foglight position.

IMG20231016124101.jpg

IMG20231016124056.jpg

IMG20231016123942.jpg

IMG20231016123938.jpg

IMG20231016123932.jpg

IMG20231016123912.jpg
 
Have you done all the relevant wiring ?
I havent done a 6.1 but if its the same as a 6 then there will likely be an additional cable from the light switch to the BCM required and also you need to check the feed wire is in place from the fusebox to the bcm, this feeds the relay that outputs to the 2 connections you populated, some vans will have this wire in place already dependant on spec

If your machine is capable of output tests then you could try manually activating the foglight output to see if they work (will also prove if the feed is there)
 
Perhaps some help here:
 
Have you done all the relevant wiring ?
I havent done a 6.1 but if its the same as a 6 then there will likely be an additional cable from the light switch to the BCM required and also you need to check the feed wire is in place from the fusebox to the bcm, this feeds the relay that outputs to the 2 connections you populated, some vans will have this wire in place already dependant on spec

If your machine is capable of output tests then you could try manually activating the foglight output to see if they work (will also prove if the feed is there)
Quick update,
Pin 9 on the light controller has a cable installed.
With my current settings the foglight turns on when I turn the wheel. Still can't get the lights to turn on or the foglight on illuminated on the display

IMG20231016160106.jpg

IMG20231016151805.jpg

IMG20231016151801.jpg

IMG20231016151756.jpg

IMG20231016151749.jpg

IMG20231016151716.jpg

IMG20231016151710.jpg

IMG20231016151703.jpg
 
Back
Top