Yeah got a new one. Ordered 4 tyres and 4 wheel alignment, booked in 31st December. Going to 35 profile all roundDid you manage to pick up a new rear wheel after ?




Yeah, but the company i got wheel from have admitted liability with manufacturing faultSo you cracked the rim with 11cm sidewall and has decided now to go with 8cm and lower load rating?
But tbh - looks better![]()
Yeah, sent me a brand new wheel for freeSoooo leighton said its their fault ?
It's 10mm difference if you calculate it. I have to park on the flat part of my drive now but can get over speed humps easy. Think mines 100mm loweredHave you noticed a difference in height since changing the tyres. My size is what you did have, often think about changing to the new size you have. But at the moment i can go over speed bumps ok without splitter hitting but not up a curb, which is fine... and i do go fishing quite a lot so tracks etc.
I have looked on tyre calculator, says about an inch difference?
Looks better now though mate and the rear lights, want to change mine to clear red too.... for the same reasons as yourself. Theyre not too bad once theyre on, but when parked up they are black.
I'm hoping not, but it is a possibility. I've checked them all over and can't see any forms of cracking etc so fingers crossed it's just the oneDoes this mean its likely that the other rims may suffer from this same manufacturing fault ?
Quite a few on the road.Does this mean its likely that the other rims may suffer from this same manufacturing fault ?






Thanks bud. I have enjoyed doing it. But, mrs sort of makes sense when she says "no more". I spend money like it's free, need to be careful......1.5hrs reading all that thread while "working"!!
Great build, looks good
don't sell, i sold my T6 thinking, I'll be happier back in a car again... now back in T6.1![]()
They're from exe.ude, really well made. Yeah I've covered the insides in vaselineI might have to get a set of the door pins.
Be careful with the valve caps - if they’re not meant for rubber and brass valves, they might seize themselves onto the valve thread
Yeah I've covered the insides in vaseline![]()