Has anyone repaired or replace the couplers on the fuel line. Remove the couplers to the sender unit to fit heater. All going well. Then I realised the push bit of the coupler was loose and broken. The housing is still intact. So I wonder if its possible to replace the push clip bit... if so does anyone know the part number or where to get them?
You can pin out the connector and replace the housing the part number will be on the connector block itself, the pins come out easy just click out the purple connector tab inside the housing and use a terminal tool to release the terminals just make note of pin locations
He is after the fuel line coupler not electrical connection methinks.
Those clips have been overtightened by the look of them, there is no need for them to be tightened so that they bulge like that. That can lead to splitting the rubber. They only need to be tightened as much that the rubbers will not move when twisted. There is no fuel pressure there only suction.
