Battery replacement eu6 obd11

[T6_FunBus]

Hi guys,

My battery died on Friday, a new one has been fitted but hasn’t been coded - I have a stop start not possible error.

Do I simply need to go into gateway - adaptation and change a number on the battery serial for the ecu to register a new battery has been fitted?

Or is there any more to do?

Thanks.

 

[mmi]

Better late than never...

T6​

• OBDeleven > Connect > Control Units > 61-Battery Regulation > Long Adaptation > Channel 4 >
• (Tap and hold on value to copy into New value)
• Change Battery Size if needed
• No need to change battery vendor - doesn't make any difference on T6
• Change Battery Serial Number (just one digit is enough, or preferably put today's date into serial number)

---

Battery adaptation using VCDS:

Upgrading Starter Battery - how to guide

My van (April 2017 T28) is fitted with a Moll battery. I am experiencing some issues with it not starting after a few days sitting on the drive. Now this could be due to the tracker I have fitted draining it but I doubt it, I'll do some drain current tests before taking the plunge. If I were to...

www.t6forum.com

 

[T6_FunBus]

Thanks mmi - have just done this and worked perfectly, just needed to ‘test’ before writing.

 

[danncus]

No mention of battery type?

 

[roadtripper]

No mention of battery type?

For a Euro6 with a smart alternator the only types that should be fitted are EFB or AGM which have the same charging profile.

If changing all you need to do is to update the capacity (if changed) and change the serial number (value is irrelevant but the change resets the learned health data from the old battery and starts fresh)

 

[danncus]

Thanks all. Battery installed and operational.