staggered wheels

Selling my 20” Axe EX30 wheels (850kg rated) Staggered set so 8.5” front and 10” rear - no clearance issues with arches or sliding door (my van was down around 70/80mm) Gloss black and 3 are unmarked and as new, the passenger rear has very minimal surface scratches in a couple of places that...

Hello everyone, This is my first post and I apologise if this has been asked loads of times but I wondered if I could get some advice on tyre sizes. I have recently brought a set of Inovit speed alloys 20 inch and they are the staggered set. It’s 8.5J ET35 on the fronts and 10J ET40 on the rears...

Hi All, Am really hoping someone can advise on the best option for tyre sizes For my 2017 T6 Four-Motion (T32). I am confused… I have just bought a set of 19” Navis Holeys which are a staggered fitment. Fronts are 19x8.5 et35 and rears are 19x10 et40. If I fit 275/45/19 on the rear (108 load...

Hi guys I’m in need of some advice I have T30 4 motion with staggered wheels (judd t311r 20” Front 9j et38 Rear 10.5 et 42 Tyres are front 245/40/20 Rears 265/40/20 question is can I keep this set up until the fronts need changing then change the fronts to 265/40/20 ? Or do I change them now ?

Hi Everyone! I hope you can shed some light on the Alloys on my van. I have attached some pics below for reference but in short I recently purchase my T6.1 and noticed that all four tyres are the same size 275/35Z/20 102W how ever it is clear that the alloys are not the same width as the tyres...

Hi up for sale are my lovely freshly refurbished rolls Royce ghost wheels in staggered 20x8.5” & 20x9.5” Anthracite grey with diamond cut faces Floating centres included and 10mm spacers for the rear also just had gloss black rings fitted around rr badge £1795ono Located near Heathrow airport...

Hi all, Selling our Inovit Blitz. They are staggered at 2 x 8.5J x 20" ET35 and 2 x 10J x 20" ET35 with Uniroyal Rainsport 5 275/35 20 Tyres. We have done just under 10,000 miles on these wheels and tyres. The front tyres are fine but the back ones are a little worn on the inside edge (from...

Hi All Was keen to keep these as i love the look on my van, but i'm going in a different direction and just can't have this much cost sitting in the garage. Wheels are INOVIT Torque 20" as per title. Fronts are 8.5 wide with ET35 and have brand new (100 miles on) Nankang AS 2+ tyres in 245/45...

Axe EX30 20” silver alloy wheels with polished face and used tyres Rears 20 x 10J ET 42 offset PCD 5 x 120mm Fronts 20 x 8.5J ET 40 offset PCD 5 x 120mm I’m told that these are load rated to 850kg Tyres will need replacing These wheels will benefit from a refurb as the lacquer is hazing and...

Up for sale are my stunning 20" Judd T311R staggered wheels finished in gloss gunmetal. They are virtually as new, purchased new by me last October from Bognor Motors. Ran for a few hundred miles then removed to fit winter wheels on. They are a staggered fitment being 10.5" (et45) wide rears...

20” Inovit Vectors, staggarded 8.5” & 10” 5 x 120 ET37 (front) ET 38 (rear) they are stamped 880kg. All in 275/35/ ZR20 102 Y XL Acelera Phi 2 Note the wheels are related for a T32 but tyres only up to a T30. Bought late 2018 but not fitted until March 2019. I took them off back in August...

Hi All, To celebrate the fact that we have very recently become a Rotiform Wheels dealer, we are offering 1 set of Rotiform DTM wheels in Silver for the much reduced price of £1135. Normal Pricing is £1285. Specs as follows: Front Wheels: 8.5 x 20" ET35 Rear Wheel: 10 x 20" ET40 These are...

For Sale as surplus to requirements A brand new unopened set of 20" Navis Schmoov steel wheels in the following fitment Front 8.5 et35 | Rear 10 et40 Diameter: 20 Inch Bolt Pattern: 5×120 Fitment Only Centre Bore: 65.1 Colour: ANTHRACITE Style: Smooth Steel Wheel Load Rating 1100kg (per wheel)...

I've had these wheels for 2 years and I've lost track of the amount of people asking me about the size and what they are off :D They are 8.5" on the front and 9.5" on the rear. I am running quite low on So-low coil overs and I don't get any rubbing at all. The tyres are load rated for a T32...

Morning all, sorry to go over old ground (again) but time has marched on since my first post and thankfully after a few disappointments my converter has finally secured me an Indium Grey T28 T6.1 DSG 20 plate (the one with the sport box - ), which is being picked up in the next couple of days...

Hi, I'm after some staggered 20 inch wheels for my shuttle if possible. Issue is the door cards on the sliding doors are thicker... Anyone running staggered on a shuttle? If so what spec wheels? Thanks in advance.

Morning Guys! After a year of scouting through the forum for information and tips i thought it was about time i introduced myself and said hello! I bought my T6 in March this year as a basic panel van and have been slowly converting into our ideal day van / camper, for taking our 2 dogs and...

Just an update for you guys, been a long time coming (thanks to shipping/covid/brexit) but finally we can announce that the Rotor and Frixion 5 will be landing late April! Rotor staggered, Frixion 5 in 20x8.5 for now, rears are on the way on the next shipment (expected mid-May) and more of them...

Hello all. I'm in need of some help finalising the width and offset combination on some Judd 19" T311r's I've got a black Kombi that's had b14's fitted lowered to the max, just waiting, for when funds dictate, to fit some matt gunmetal Judd's. I can visualise what i want but can't put it in to...

I’ve just been reading an old post regarding 20” staggered alloys rubbing the door cards on a caravelle? Does anyone know if this is down to the wheel/tyre combo or will this happen with any set up? I’m looking to go down the staggered route with either LV-1 or the Judd 311’s TIA