Wolfbox install
- Thread starter dave_b
- Start date
I had a Quick Look at the wiring to the already installed camera.
It’s routed through the gator on the door and then is probably spliced into existing wiring to activate it when reverse mode is engaged.
I’ve disconnected the camera (there was a plug connector) and I’ve also snipped the wire at the rear view mirror screen. So all I have to do now is trace the existing wire and replace, or run the new alongside the existing.
Disconnecting the existing has not caused any bulb faults so I don’t see a need to rip out all the existing camera wiring.
But, how do I get to this access point from within the van? I guess it’s a simple case of removing the interior trim (marked with a yellow cross) which is simply screwed on (much like the door cards).?
It’s routed through the gator on the door and then is probably spliced into existing wiring to activate it when reverse mode is engaged.
I’ve disconnected the camera (there was a plug connector) and I’ve also snipped the wire at the rear view mirror screen. So all I have to do now is trace the existing wire and replace, or run the new alongside the existing.
Disconnecting the existing has not caused any bulb faults so I don’t see a need to rip out all the existing camera wiring.
But, how do I get to this access point from within the van? I guess it’s a simple case of removing the interior trim (marked with a yellow cross) which is simply screwed on (much like the door cards).?
I second this. Was quite simple. Had to gather a lot of excess cable up and tie it back there but it went fine considering I'm thick... edit: I have a T6 so not really relevant sorry hehe
Pull the panel off the right side of the dash, and you have a clearish route to the fuse box.
I went down the a pillar and then poked the wires through the hole behind the panel of previously removed.
Yes. Pull that trim off by your yellow cross and you get to the end of the rubber bellow grommet thing.
I went down the a pillar and then poked the wires through the hole behind the panel of previously removed.
Yes. Pull that trim off by your yellow cross and you get to the end of the rubber bellow grommet thing.
I’ve searched the forum, but don’t see anything to answer my latest question.
I’ve bought a Wolfbox G900 dashcam / rear view mirror. Research on here showed that I needed a bracket to go between the wolfbox mirror and the bracket on the screen. I’ve gone to fit the wolfbox and the bracket is completely different.
I’ve never come across this before and seems to be a standard VW bracket. I can cobble these parts together in an OEM looking way, but…
here’s my question. One sensor will stay in the bracket on the screen. What will happen if I don’t connect the sensor that is in...
I’ve bought a Wolfbox G900 dashcam / rear view mirror. Research on here showed that I needed a bracket to go between the wolfbox mirror and the bracket on the screen. I’ve gone to fit the wolfbox and the bracket is completely different.
I’ve never come across this before and seems to be a standard VW bracket. I can cobble these parts together in an OEM looking way, but…
here’s my question. One sensor will stay in the bracket on the screen. What will happen if I don’t connect the sensor that is in...
I don’t like the rubber straps around the mirror so I’ve ordered the Wolfbox bracket.
How do I get this mirror fixing off the windscreen?
What bracket will I need to attach to the windscreen to fit the Wolfbox bracket?
How do I get this mirror fixing off the windscreen?
What bracket will I need to attach to the windscreen to fit the Wolfbox bracket?
I have no sensors or anything in my mirror. I’d rather leave the round thing in place and glue another bracket to the screen for the wolfbox
Similar threads
