Hi, I’m Troy, new to this forum, a would appreciate any advice. My 70 plate T6.1 windscreen washer is not working. Bottle full. No noise of pump trying and both rear and front screens are not getting fluid. I pulled the one and only 15amp fuse but the wipers still work so I am not so sure that fuses is protecting the pump motor. Is there another fuse? Thanks
Windscreen washer not working
- Thread starter TroyRos
- Start date
Mine did this.
The bottle is just in front of the front, passenger side wheel, low down behind the lower bumper. There's an little access panel in the wheel arch protector, if you turn the steering all the way to the right and you'll see it.
The pump is in the bottle, the contacts are on the rear of it and outside the bottle and are quite vulnerable to the elements. From memory, the pump will slide out without tools. You may get water loss depending on how full your washer bottle is!
I took it out and cleaned everything, and then used a water repellent contact spray and it's been good ever since.
The bottle is just in front of the front, passenger side wheel, low down behind the lower bumper. There's an little access panel in the wheel arch protector, if you turn the steering all the way to the right and you'll see it.
The pump is in the bottle, the contacts are on the rear of it and outside the bottle and are quite vulnerable to the elements. From memory, the pump will slide out without tools. You may get water loss depending on how full your washer bottle is!
I took it out and cleaned everything, and then used a water repellent contact spray and it's been good ever since.
Frozen?
