Particulate Matter Sensor

[BenWomersley]

Had a warning light and error code P24C600 (particulate matter temperature sensor failure)

2019 T6, CXFA 150hp

I have bought a replacement sensor:

04L906261F - Bosch 0281007046/047

it has arrived today and I have just double checked compatibility to see that it isn't compatible with pr number 7CS. Just checked my data sticker to see 7CS.

I can't seem to find an appropriate replacement sensor. Apparently I am looking for:

04L906261G - Bosch 0281007405/406

Can anyone tell me where I might be able to find one / if the one I have will work? Everything I have read suggests the 'G' version is a slight update and is backwards compatible but can't see the 'F' version will be forwarded compatible.

Thank you!

​

 

[manfrotto]

See this thread -

J

Thread 'Particle sensor fault'

27 Mar 2023

Can anyone help , I have a 2019 t6 with 29670 on the clock and it’s 14 weeks out of warranty! Had the engine light come on p24c600 passive /sporadic particle matter sensor circuit and passive/ sporadic particle temp sensor temperature circuit , reset went off for two weeks now back on reset and on following day also noticed the adblue counter stuck on 5000 miles and no dilution figures ? Guessing the sensor has had it . Rang vw been given part no 04L906261G but non in stock everyone else I ring says it should be 04L906261F which is about £140 cheaper does anyone know the difference even...

• juggy1
• Replies: 4
• Forum: Vehicle Faults, Warranty Repairs Issues & Problems

Did you check what version your current sensor is? It is likely version F anyway.

 

[BenWomersley]

I read that yes: they didn't say if they had the 7CS pr number so wasn't sure if theirs would be happy with the cheap(er) and available unit and mine wouldn't.

I haven't no, I will try to pop my head under shortly and see

 

[manfrotto]

There is also a Tech bullletin about drilling a hole in the CAT to allow condensation to drain out (this is often what causes the sensor to fail)