Hi @Snakelimit, are you using the original controls in the seat or new ones? Would love to see some photos if you’ve gone for a customised approach ?
Audi RS4 Seat Upgrade
- Thread starter Mickhar
- Start date
-
- Tags
- audi seat upgrade
Ye mine dint work as somone try before me and most likly burn modules or block them
I will get photos later I forgot to do so lol
I will get photos later I forgot to do so lol
I used a basic ON/OFF/ON switch with 6 pins on the back. The two middle pins are for the power input (+ and -). On one end, I connected the output wires in one polarity (+ and -), and on the other end, I reversed the polarity (- and +). This way, I can change the direction of the DC motor, as it can run in either direction depending on the wiring. Sides connected to motor
Very nice ! Where did you get the black back plate to fix the switches to ?
It’s orginal one I cut out holes after I removed orginal buttons I put a pice of fabric fake leather to hide imperfections
If you can post what did you use parts wise I can understand a bit as polish but not all 
Bigbaz1973
New Member
I’ve also fitted rs3 seats to my t6.1 transporter what have you done with the seatbelt wires when I unplug the t6.1 wires it brings an air bag light on with a seatbelt open circuit code there’s 4 wires on the Audi seats so not sure what to do thanks any help much appreciated
I did not connect mine but mine t6 and nothing lights up
I took a different approach in the end and bought old Audi Electric seat controllers, which work directly from a 12v feed. Sadly they don’t fit in the trim but I have wired the so they pull out from under the seat on a long cable.. (like a wired gaming controller)
Must be older version as mine was connected to module not motors
Both of my Audi seats had a module too as that controlled all the seat functions including the motors. I just took those out and cut the connectors off so I had direct access to each of the seat’s motors.
Similar threads
