Under body protection

[Stephen Harris]

HI Everyone.
Has anyone used the "Lanoguard " under body protection stuff that keeps popping up on various sites??
Or is there anything more suitable.
I ask because, after recently changing the rear wheel sensors on my 2018 T6 (post in "vehicle problems section") I noticed the suspension arms and various other bits are taking on a rusty colour!!
I would like to address this but wondered if a coating of the lanolin might just result in a sticky coat attracting filth!!
My T6 has only done 23500 miles from new and I would like to keep it from deteriorating further.
Regards. Steve Harris

 

[Sasquatch]

Try the Buzzweld lano sprays. IMHO better than Lanoguard as it leaves a thicker and much more robust film, and is much less expensive. Once cured it's only very slightly sticky, if at all, and doesn't attract a film of dirt to make a mess.

Built Hamber Dynax UC is chemically similar, but pricy. A good performer though.

The beauty of these clear film jobs is they leave the surface beneath visible so rot can't spread unseen, and can be applied over firm rust thats been sanded back. They also require the minimum of prep and take only half an hour annually to top up.

 

[Stephen Harris]

Thanks for that and sorry to take so long to reply.
Regards. Steve Harris

 

[Sasquatch]

Steve Harris

Not Bomber Harris the bassist by any chance...?

 

[CAB]

Not Bomber Harris the bassist by any chance...?

T666........