Turbo boost sensor 03K 906 051
- Thread starter JOHNST6
- Start date
Looks like the MAP Sensor (Manifold Air Pressure) on the front of the Engine. Was looking at this a couple of days ago on mine, and what a pain it would be to get at. Front end would most likely need to go into the "Service Position" to create enough room to get at it.
If i remove the EGR pipe which is just above it in the picture i think its do able... is that pipe a simple take off and bolt back on when done ?. My second question is that sensor the Turbocharger Boost Sensor P023600
Not certain about the sensor ID, it will measure air pressure from the inlet into the charge cooler so possibly what you are looking for. The EGR Pipe does have gaskets which I believe are "crush" type, and probably need renewing. You should also confirm your Engine code and sensor location. Had a quick read of some info and it looks like there are possibly different locations for "G31 boost sensor"
Last edited:
Thanks for the reply i can see a sensor just below the pipe VIN: WV1ZZZ7HZKH081583
Car: Volkswagen Transporter
Year: 2019
Body type: VAN
Engine: CXHA
Last edited:
CXHA code matches up with the picture you showed originally, so yes, I would take that as the boost pressure sensor. Have you ruled out air leaks in the system as well? That could give false signals back to the ECU I would think. You have VIP membership and can access all the same info in the downloads. Best of luck, hope you get it sorted
Thanks for all info and help it's much appreciatedCXHA code matches up with the picture you showed originally, so yes, I would take that as the boost pressure sensor. Have you ruled out air leaks in the system as well? That could give false signals back to the ECU I would think. You have VIP membership and can access all the same info in the downloads. Best of luck, hope you get it sorted
