Pop top matteress
- Thread starter Markp89
- Start date
Might help if you provide the dimensions of your bedboard and the size of the gap between the bedboard and the roof when the roof is down.
Also, you should not be sizing "canvas to canvas" - if the mattress is touching the inside of the canvas, it will encourage water ingress through the canvas when it rains.
Also, you should not be sizing "canvas to canvas" - if the mattress is touching the inside of the canvas, it will encourage water ingress through the canvas when it rains.
I have a Storm poptop that I used for the first time this weekend. I purchased the mattress from Storm but found it quite uncomfortable. I bought a 1cm Sleeping mat to put under the matteress but even that was too thick for the roof to close properly. Would love any suggestions?
shepswansjack
New Member
I've just bought an "Outdoor Revolution Camp Star Top of the Pop", just tried it today, brilliant fit, super comfy, but i cant close the pop top down, i undid the valve to let air out, pulled the sides in a bit, and the top just wouldnt sit down right, so i took it back out, no major hardship, think my board is a little bit thicker, so I've just had to roll it up again, but at least i know fits and feels very comfortable
I think you will not find a canvas to canvas one that let you close the roof, at least on my Skyline the dampers would be in the way.
I use a topper together with the Vango PopTop 5cm.
The roof can only be shut when the valves are open and I need to pay more attention to getting the canvas tucked in.
I use a topper together with the Vango PopTop 5cm.
The roof can only be shut when the valves are open and I need to pay more attention to getting the canvas tucked in.
shepswansjack
New Member
Think coz mine got only one valve and its like sponge inside... well it wont sit down, no point in trying, 
