Harrison Trim Supplies Flooring - Cut to shape

T6ChrisO

AutoCAD engineer
VIP Member
T6 Legend
Hey all,

Has anyone used the readily cut to shape flooring from Harrison Trim Supplies? Is it a good fit?


Cheers
 
Not personally, but having seen one in the flesh it looked good. Practically every converter round the local area uses them.
 
Not personally, but having seen one in the flesh it looked good. Practically every converter round the local area uses them.
Yeah its more so the fit of the cut to shape im interested in. I think most if not all converters probably buy a roll and cut each job to suit
 
Not exactly what you were asking but I bought our Altro from Combe Valley - spot on. I can't remember where they ship from but could well be Harrison.

I'm fussy so took about a mm off around the wheel arch on 1 side but it's going to be covered by furniture, unless all of the floor is going to be visible, its perfect and even then a 10 min job to make it so.
 
I got a cut to shape one, but then discovered that because I have a Reimo 3000 bed with a very thick and slightly longer floor, it wasn’t quite the right shape. I took it back and they were very happy to swap it for a regular length.

If you are doing a regular floor, I would thoroughly recommend it, it will save you a pile of time and potential frustration.
 
View attachment 308171

I offered it up to check the fit as I'm not installing it until the poptop, windows and carpets are done but it fits quite well. A few slight trims here and there and it'll be snug.

It feels very durable
Thats great to hear. I purchased it too but its still rolled up in the back of the van. Might tackle it this weekend
 
Back
Top