H&R Lowering Springs

[RyanTay]

Hello,

I currently have a 2020 T6.1 T28, on 20inch alloys, I would love to lower the van to look more appearing but keeping the vehicle practical for camping caring weight etc.

I have considered the coil overs but the price is high when in all honesty I don't want to be changing the vehicle high to suit vehicle purpose (I'm not looking to slam the vehicle down)

i believe from reading online the H&R 35mm lowering springs are a good option? & I know its probably a question that cannot be answered till its done but what the van would look like once fitted.

as everyone can understand we all want the vehicles looking the best they can without jeopardising the vehicles drive & practicality & of course spending a fortune

if anyone has fitted the H&R springs and can show photos & tell how it drives it much be much appreciated, any advise is greatly welcome!

Thank You,

Ryan.

 

[CRS Performance]

Hello Ryan

The results fitting springs onl y are never that good , H&R only make one kit for the T6.1 ( as apposed to 8 for the older T 6 ??? go figure )

If its a camper fitting springs alone will accentuate the saggy back end and this isnt good .

Measure the wheel arch gaps and compare front to back , they should be the same , if the rear is lower than the front only fit the front lowwering spring and try to level it out