My setup is a bit unique so difficult to confirm 100% and here's why...
I have a Jennings "lowered" seat base designed to allow a swivel base to be fitted without adding height. I think this is about 30mm lower than normal. I then have some seat adapters that allow VW Tiguan (and other VAG car) seats with wider rails to be fitted. These add back some height (I think about 30 mm).
So I think I'm at about stock seat base height. With that configuration, the two Renogy core mini batteries fit upright under my seat, but there is zero spare height/clearance. The seat cross-beam that is part of the rail slider mechanism just clips the rubber terminal covers on the first battery if I'm adjusting it back and forward. I'm ok with that as the covers are rubber and I don't regularly adjust the seat once it's in position.
Also note that the dedicated MPPT was included free in the bundle and I'm not planning to use that as the DC-DC has a built-in MPPT.
Here's a picture of the way I installed everything, but I just can't guarantee they would fit in a standard base.
It's in that mess of wiring to the left of the batteries. You can just see it in this picture. So the wiring between the starter battery and DCDC has an 80A midi fuse at each end.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.