Engine management light

denz1968

Senior Member
VIP Member
T6 Guru
So the dreaded EML came on. 2 weeks outside of the three year warranty period.

Looks like adblue related. Any advice or tips please. Error codes were cleared but light back on again.

IMG_6813.webp
 
  • Sad
Reactions: CAB
Is the van driving OK, or is it in limp mode?

Have you checked the wiring, especially to the ECU?
Do you get a message on the dash to say that your Adblue needs filling?
Any other fault codes other than the ones above?
 
Van drives ok.
No limp mode.
No other codes than those shown
No other error messages in the display
 
It sounds like a wiring, low voltage, earthing type issue.
What is the battery condition like?
What diagnostic tool are you using? - may need to get a a more detailed scan using VCDS or similar.
 
The two bottom faults are logged because of a faulty coolant bypass valve, located on the passenger side - near the gearbox.

It will require a replacement bypass valve.
 
It sounds like a wiring, low voltage, earthing type issue.
What is the battery condition like?
What diagnostic tool are you using? - may need to get a a more detailed scan using VCDS or similar.
So if we suspect an earth problem - any places to take a look for starters?
 
So got it VCDS checked at my convertor on Friday as had to go in for another item to be sorted.

Turns out it is my driver speaker isn't working and has become disconnected and caused the little yellow light.
So will need to take door card off and sort that out.
 
Back
Top