Guys, I've royally cocked up. While fitting a switch I used a 20mm Hole cutter and caught the wiring loom in the near side box section that was added for the pop top. So far faults that have come up are ABS, stability control & start stop. I can see the damaged wires can I splice in a new piece or is this going to be a nightmare repair? Thanks all!
Damaged wiring loom
- Thread starter Kc6913
- Start date
I would definitely go for inline spices and stagger the splices so there isn't a big bulge at the repair area.
If you methodically splice in new bits of wire, solder and insulate with heat shrink it will work as before providing you colour match the broken wires.
You may need to reset the faults with VCDS or Carista but providing the wires are repaired correctly all will be fine.
Ian
You may need to reset the faults with VCDS or Carista but providing the wires are repaired correctly all will be fine.
Ian
