I’m currently in the process of replacing my rear tail lights, the offside light came off no problem, but the drivers side would not budge. After being a “bit” more forceful I managed to break the clip
Anyone got any advice how I can remove this without using a big hammer?
That was my first go to and after 45 minutes I needed to go and cooldown . I was hoping someone might have a special technique, before I give it another go tomorrow.
Thanks for all the advice guys, in the end I spent around another hour going through every tool in my toolbox, I have no idea how I did it in the end, but I got the thing off. Next time I'll definitely remember the correct technique and not break the clip as I don't want to have to go through that again
Was you trying to depin the connection so you could swap the wires around or get the connection off? If the connection is damaged you should be able to see a part number on it so it can be replaced. It will just need to depinned and swapped over.
Was you trying to depin the connection so you could swap the wires around or get the connection off? If the connection is damaged you should be able to see a part number on it so it can be replaced. It will just need to depinned and swapped over.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.