2018 T6 fault codes

[T6_adz]

Good Morning,

Apologies if this is already being discussed however I couldn’t see any of these whilst looking through last night.
Yesterday, had this happen to my van, the DPF light came on so I initiated a regen and went for a drive but then the EML came on and the coil light was flashing at me and now I can’t seem to reset the codes. Could anyone please point me in the right direction or potentially know anyone near Lossiemouth with VCDS that may be able to provide more of an insight?

I have this from my carista

Engine:
P245800 - Particulate Filter Regeneration Duration Bank 1
Freeze frame :
Priority: 2
Malfunction frequency counter: 1
Unlearning counter: 255
Odometer reading: 134625.6 miles
Engine rpm: 0 RPM
Normed load value: 0 %
Vehicle speed: 0 mph
Coolant temperature: 70 °C
Intake air temperature: 35 °C
Ambient air pressure: 14.65 PSI
Voltage terminal 30: 12.156 V

U100300 - Trailer recognition control module: No communication
Freeze frame :
Priority: 2
Malfunction frequency counter: 1
Unlearning counter: 255
Odometer reading: 134625.6 miles
Engine rpm: 0 RPM
Normed load value: 0 %
Vehicle speed: 0 mph
Coolant temperature: 70 °C
Intake air temperature: 35 °C
Ambient air pressure: 14.65 PSI
Voltage terminal 30: 12.156 V


Instrument cluster:
U112100 - Databus missing message
Freeze frame :
Priority: 6
Malfunction frequency counter: 1
Unlearning counter: 120
Odometer reading: 134625.6 miles


Thanks in advance,

Adam

 

[mmi]

P2458

Same fault code - not sure if there is anything useful in these...

K

Thread 'DPF - Regeneration duration error'

17 Aug 2022

Hi.
Got a faultcode on my car today.
23967 - diesel particulate filter
P2458 00 - Regeneration duration.

have just changed the engine over for a new one, and only driven about 150km.
i have tried a service regeneration, it goes like normal, revs up and keeps revving while it says running in the vcds, but it have been standing for that for like an hour but it does not seem to regenerate the filter.
looked at the ash mass, looks to be like 32g.
cant erase the fault, and cant seem to get it to force regeneration, any suggestions?

had a faultcode earlier for exhaust gas temp sensor 2, but...

• Kaph
• dpf regen
• Replies: 7
• Forum: Engine, Gearbox, Exhaust, Drivetrain

Thread 'Fault codes P5824'

8 Sep 2022

T6 T32 5speed gearbox 2litre engine 2017 53.999 miles.
Got 2 fault codes from carista P5824 DPF Regeneration Duration and P2463 DPF restricted soot accumulation. Engine fault 23902 and 23967 both say manufacturer specific code. Got the coil light flashing Amber and engine light on steady Amber light. On carista it came up with soot level 59 99% and press here for a regen which I have done 3 times now and nothing has happened (revs 2000/2500 for 20mins each time )
Van runs OK with no signs of smoke out of exhaust, no loss of power, no knocking noise from engine, no uneven revs on...

• sam wildcat
• fault codes
• Replies: 2
• Forum: Vehicle Faults, Warranty Repairs Issues & Problems

 

[T6_adz]

Same fault code - not sure if there is anything useful in these...

K

Thread 'DPF - Regeneration duration error'

17 Aug 2022

Hi.
Got a faultcode on my car today.
23967 - diesel particulate filter
P2458 00 - Regeneration duration.

have just changed the engine over for a new one, and only driven about 150km.
i have tried a service regeneration, it goes like normal, revs up and keeps revving while it says running in the vcds, but it have been standing for that for like an hour but it does not seem to regenerate the filter.
looked at the ash mass, looks to be like 32g.
cant erase the fault, and cant seem to get it to force regeneration, any suggestions?

had a faultcode earlier for exhaust gas temp sensor 2, but...

• Kaph
• dpf regen
• Replies: 7
• Forum: Engine, Gearbox, Exhaust, Drivetrain

Thread 'Fault codes P5824'

8 Sep 2022

T6 T32 5speed gearbox 2litre engine 2017 53.999 miles.
Got 2 fault codes from carista P5824 DPF Regeneration Duration and P2463 DPF restricted soot accumulation. Engine fault 23902 and 23967 both say manufacturer specific code. Got the coil light flashing Amber and engine light on steady Amber light. On carista it came up with soot level 59 99% and press here for a regen which I have done 3 times now and nothing has happened (revs 2000/2500 for 20mins each time )
Van runs OK with no signs of smoke out of exhaust, no loss of power, no knocking noise from engine, no uneven revs on...

• sam wildcat
• fault codes
• Replies: 2
• Forum: Vehicle Faults, Warranty Repairs Issues & Problems

Thanks, came to the van this morning and it’s in limp mode now too so I’ve put it into the local garage. it’s nothing too serious