Wiring engine bay to cab

StratosFearXX

Member
VIP Member
T6 Pro
I've searched and searched so posting new thread, T6.1, is this (grommet, see pic snapped from a YouTube vid of T6) still the route to take from engine bay to cab in 6.1 please?

Screenshot_20250516-100608.png
 
So I know how to get to the grommet in the plenum chamber I think, how much stuff do I need to take off on the inside? There's some grey sound proofing stuff under the rubber matting ...

I need to get a 4mm² twin core cable through?
 
For anyone that finds this thread and is wondering, the grommet hole was much higher than I was expecting from the inside but glovebox out (not too bad a job) and you can poke your wire through and it'll come out above the blower fan motor. Then you can thread it down to the floor and route it to wherever you want it.
 
Back
Top