T6 204 BiTDi dsg solenoid valve x3 ???
- Thread starter Jme Jme
- Start date
In the picture
left: wastegate actuator solenoid
middle: turbine changeover valve actuator solenoid
right: turbine vane actuator solenoid
P00AF 00 - Actuator Module for Turbocharger 1- Stuck
P2563 00 - Turbocharger Boost Control Position Sensor Circuit - Implausible Signal
left: wastegate actuator solenoid
middle: turbine changeover valve actuator solenoid
right: turbine vane actuator solenoid
P00AF 00 - Actuator Module for Turbocharger 1- Stuck
P2563 00 - Turbocharger Boost Control Position Sensor Circuit - Implausible Signal
Next step would be to check the actuator module.
A proper diagnostics tool would save time, and probably also money. As e.g.
Indeed, well out of adjustment - the sensor voltage engine stopped should be about 3.7 Volt and idling at 0.75 Volt.
The same also seen in a test here -
www.t6forum.com
A proper diagnostics tool would save time, and probably also money. As e.g.
Please post
Tick/fill boxes as above and click Go.
VCDS flashes screens for a moment (when finished hit "Done, Go Back") and there should be files blockmap-01-... in folder C:\Ross-Tech\VCDS\Logs\....
PS. For the above either VCDS HEX-V2 or HEX-NET cable is needed.
(1) - engine's blockmap data - engine not running (ignition on)
(2) - engine's blockmap data - engine ticking over (idling 830 RPM)
VCDS > Applications > Controller Channel Map >
Tick/fill boxes as above and click Go.
VCDS flashes screens for a moment (when finished hit "Done, Go Back") and there should be files blockmap-01-... in folder C:\Ross-Tech\VCDS\Logs\....
PS. For the above either VCDS HEX-V2 or HEX-NET cable is needed.
Indeed, well out of adjustment - the sensor voltage engine stopped should be about 3.7 Volt and idling at 0.75 Volt.
The same also seen in a test here -
[T6_measured] 01-Engine - Built-in tests for turbocharger
01-Engine - Basic Settings IDE00457-Test of turbocharger HOW-TO Engine running VCDS > Select > Engine > Basic Settings > IDE00457-Test of turbocharger Select "Show Measuring Data" Pick up e.g. the following data items for monitoring: IDE00021 Engine RPM IDE00347 Air mass: actual value...
I think the thread below is very useful - the same for DAUA engine. The actuator needs to be removed for adjustment...
Similar threads
