Hi folks, as I say, its a Crafter issue and I've posted on the Crafter Forum. Pulled a fuse, replaced and now have a warning light. Any ideas why or how to resolve please?
Now sorted....Crafter but any ideas ? Fuse pulled, now a warning light.
- Thread starter Dannyb6467
- Start date
Ignition was turned on?
Should turn off by itself after a few ignition cycles.
Hmm
perhaps then not related to the fuse.The warning light is about emission system malfunction.
I don't think it makes a difference. But of course doesn't hurt to try.
A fault code reader would be helpful.
Ill try cycling the ignition tomorrow then if no good ill disconnect the negative. Thanks though...Hmm
The warning light is about emission system malfunction.
I don't think it makes a difference. But of course doesn't hurt to try.
A fault code reader would be helpful.
Well....all warnings are now off. 2 days and 289 miles later they sorted themselves out. Thanks for the comments though
Similar threads
