No clutch. Stuck in reverse

[flyingging]

My Monday morning manufactured van is stuck on my drive in reverse with a faulty slave cylinder I'm told. How do i get it out of gear. Tried starting it and ended up heading to my garage doors !
I have a pool of fluid and a pedal on the floor with no pressure. T6 4motion.
Any help appreciated.
Cheers

 

[Mud Digger]

is the van parked on a angle / slope you will need to take the pressure off the gear box .... have you any help just to push the van slightly

are you replacing the slave ... it' ll be alright sat there while you fix it it might just pump the once if you added a little fluid

 

[Mike23864]

Have you anyone that can help rock it backwards and forwards whilst you put it in neutral?

 

[flyingging]

Have you anyone that can help rock it backwards and forwards whilst you put it in neutral?

I have managed it by rolling a wee bit. I have a steep drive towards my doors !

 

[flyingging]

I have managed it by rolling a wee bit. I have a steep drive towards my doors !

Thanks Mike.

 

[Long tall John]

If you can’t roll it back could you jack the front end up to relieve the tension? Make sure you chock the rear wheels though!

 

[Littleblackflash]

can you jack up the front wheel off the ground, leaving the handbrake on?

 

[flyingging]

I'm not very impressed with the T6.
Crankshaft tries to fall off at 90,000 miles. Clutch slave cylinder gone now, Steering pump noisy too and only 114.000 miles. What next ?
My 2.5 T5 did better. Just the cam shaft at 160,000 miles.
For £38,000 not impressed and the new one would cost £55,000 ? For a t32 140bhp 4motion kombi ?