Installing Webasto Diesel heater in Van with Factory Nordic pack

[T6NOMAD]

Question for the guys that have already done a similar installation:

I am currently installing a Webasto ST 2000 heater in my T6 Swamper and I have hit a speedbump.

As you can see in the photo below, the space where you would normally drill a hole to install the feed tube for the diesel heater is occupied by the feed line for the Nordic Pack heater.

Where would I drill a hole to install the feed tube for the Additional Webasto heater? Any available spot?

 

[oldiebut goodie]

You just tee off the other heater. Plenty of threads about it. I am lying in hospital at present so you will have to search it for yourself, 8mm/4.5mm tee required..

 

[T6NOMAD]

You just tee off the other heater. Plenty of threads about it. I am lying in hospital at present so you will have to search it for yourself, 8mm/4.5mm tee required..

Firstly wishing you a speedy recovery.

Thanks for the tip, I tried searching but didn't know what to search for. Will check it out and will provide feedback here

 

[rippelep]

I did it with this, I have a autotherm 2d airheater installed and added a webasto water heater. They can use both the same source as both have their own metering pump. No need to go to the tank pump again.