Haldex gen 5 capacity

Der55

New Member
VIP Member
Just changed the oil cleaned the strainer and did the pump learn ...it was filled till running out ..then Plugged ..

After the learn was done ...took fill plug out ...no oil as expected...thought a wee top up till running out again..

Went to top up and found I had already used most
was left with like 20 ml in the 850 bottle
Must have used most on initial fill

Will need to still top up ?
 
Just changed the oil cleaned the strainer and did the pump learn ...it was filled till running out ..then Plugged ..

After the learn was done ...took fill plug out ...no oil as expected...thought a wee top up till running out again..

Went to top up and found I had already used most
was left with like 20 ml in the 850 bottle
Must have used most on initial fill

Will need to still top up ?
I have just done mine yesterday and today. I used all the 850ml from the bottle and it didn't over flow. Made sure van was level. Today's air temp is 22 deg C so within the temp spec. My van is a 2018, had it from new. Only done 20,250 miles but over 4 years old so thought I would do it. Oil and filter were clean a a whistle lol.
Same question as Der55
 
I bought more ...and it did take approx 150 ml extra ...before running back out the fill ...therefore about 1 litre in total used

Done about 600 miles since ...no issues
 
Further to my earlier reply. The oil came in a rectangle can so I checked inside and there was about 20 ml oil remaining. I sucked this out and about 10 ml was enough to cause the Haldex to overflow. Sorted. Some You tube videos stae only 650ml is required and use a little oil to rinse out the Haldex. Good job I didn't. Regards Stephen
 
Back
Top