EGR system blanking plates on the DNAA, t6.1

[Meg1]

Hi,
Does anybody know if If there are any EGR blanking plates available for the dnaa, t6.1
I was under the impression that the plates that are widely available for the t6 would fit, but I've been informed by Darkside developments that this is not the case and, The EGR system on the DNAA engines are different and the gaskets don't match either.
Cheers!

 

[DXX]

If you can get a pipe off to use the flange as a pattern make some from some stainless steel shim, nominal 0.5mm should be OK. Ebay purchase.

 

[Meg1]

If you can get a pipe off to use the flange as a pattern make some from some stainless steel shim, nominal 0.5mm should be OK. Ebay purchase.

Good call!
That's probably what I'll more than likely end up doing, thanks!
I don't think the information I've been given is correct as the upgraded t6.1 pipe I have installed as standard fits the t6, so I would imagine the plates are the same too!

 

[DXX]

I think they probably are too, DS plates are very thick apparently, not an ideal fit.

 

[DXX]

You do know that you can’t just blank of the EGR and that’s all. It has to be mapped out otherwise you’ll get a dash light.
EDIT: Isn’t that a Bosch ECU which can’t be mapped?

 

[mmi]

The EGR system on the DNAA engines are different

Correct - DNAA has two EGR's, and coolers.

 

[DXX]

Twice the fun

 

[Meg1]

You do know that you can’t just blank of the EGR and that’s all. It has to be mapped out otherwise you’ll get a dash light.
EDIT: Isn’t that a Bosch ECU which can’t be mapped?

Yes I'm getting the software done. I'm just waiting on the ECU to come back from Germany,
Autotuners finally cracked the Bosch ACU last week

 

[DXX]

Correct - DNAA has two EGR's, and coolers.

What’s the change for, is it two stage to get the inlet gases even cooler or variable gas flow rate?

 

[FWhite]

What’s the change for, is it two stage to get the inlet gases even cooler or variable gas flow rate?

If I remember correctly it is one working at low engine temperature and one at higher.