Dash cam feed not affected by Stop/Start?

PJ134

PJ134

Member
VIP Member
T6 Pro
Hi all
I’ve tried searching for this but without success, but does anyone know if there’s a fuse I can piggyback for my dash cam wiring which isn’t affected by the Stop/Start? Currently whenever the St/St kicks in the dash cam turns off and back on when the engine starts again. Van is a 2021 T6.1 Startline/Business.
Cheers
 
That’s not normal behaviour, where have you connected it ?
An ignition live circuit from the fusebox should be fine
 
Pauly said:
That’s not normal behaviour, where have you connected it ?
An ignition live circuit from the fusebox should be fine
Click to expand...
Just checked and it’s in F46. Does that sound right or should it be in a different one?
Cheers
 
My mate wired mine in and mine does the same.
Sounds like I need to swap the piggyback fuse on mine too. Mines a 2022 Sportline.
 
This could be down to the dashcam and not the van. My dashcam has a low voltage cut off to protect the SB from being discharged when in parking mode. The dashcam could be seeing the Volt drop when the van restarts or stops and automatically shutting down. The threshold for shutdown is in the dashcam settings, or at least it is on mine.
 
Salty Spuds said:
This could be down to the dashcam and not the van. My dashcam has a low voltage cut off to protect the SB from being discharged when in parking mode. The dashcam could be seeing the Volt drop when the van restarts or stops and automatically shutting down. The threshold for shutdown is in the dashcam settings, or at least it is on mine.
Click to expand...
Good point, Salty, I’ll check it out. My dash cam is one of those that doubles as a rear view/reverse camera that covers the rear view mirror and it came came with the van.
Thanks for the advice 👍
 
My Nextbase would cycle off and on with the stop/start so I added a capacitor into the supply to keep the voltage up briefly and that blew the fuse so I added a resistor to reduce the charge current and a diode on the output.
That didn’t work!
There I swapped the battery in the Dash cam and it's fine now!
 
MikeWillmott said:
My Nextbase would cycle off and on with the stop/start so I added a capacitor into the supply to keep the voltage up briefly and that blew the fuse so I added a resistor to reduce the charge current and a diode on the output.
That didn’t work!
There I swapped the battery in the Dash cam and it's fine now!
Click to expand...
I’m having that issue, what type battery did you change too?
 
You must log in or register to reply here.

Similar threads

W
T6.1 new battery and paired through Carista but still coming up with start/stop error on dash
Replies
6
Views
335
Drifterman
Drifterman
M
Starter Battery not chargins from CTEK MXS5
Replies
4
Views
858
MartinR
M
C
Dash Cam Mystery
Replies
8
Views
2K
jayc001
J
Z
Multiple systems not working after going through big puddle.
Replies
7
Views
2K
Pedro20001
Pedro20001
K
Carista not fing my T6.1 car
Replies
0
Views
377
Katteja
K
Back
Top