Anyone know what this part is called pls?

[CaravellaBus]

It fixes the rear bumper to the under side of my T6 Caravelle. Here is an image of the broken part and one that is still in tact. Been looking everywhere! Fearing it might actually be part of the bumper

 

[EAN]

Those mounts are unfortunately part of the rear bumper and not separate parts.

 

[Rich20]

A flat metal bracket bolted to each broken piece to join them together will work fine. It’s not a structural part of the bumper, just a bracket to hold it in place.

 

[CaravellaBus]

Those mounts are unfortunately part of the rear bumper and not separate parts.

Thanks. Sounds like a duct tape job!

 

[CaravellaBus]

A flat metal bracket bolted to each broken piece to join them together will work fine. It’s not a structural part of the bumper, just a bracket to hold it in place.

Thanks Rich. Good shout

 

[Ayjay]

Thanks. Sounds like a duct tape job!

Just that - keep it simple (but give it a good clean before using the bodge tape).

 

[DXX]

That’ll be the one thing that stiffens up the plastic moulding with the rigidity of a crisp bag allowing it to be called a ‘bumper’.

 

[DXX]

Araldite Rapid and glass fibre tape, good as new.

 

[Paynewright]

Damageundone on Instagram has some good vids on plastic welding bumpers, typically reconstructing broken tabs.

 

[Sasquatch]

Id sandwich that between two strips of alu, perhaps 1mm thick each to allow a degree of flex, bonded in place with Sikaflex and gently clamped while it cures.