I have just put down a 15mm hex floor which has the anchor points cut out, thanks to @Vanbus it fits perfectly. What I need to do is raise the anchor points so they sit flush with the floor, I can’t seem to find any aftermarket ones to use for this, the t6.1 I have have two bolts in each one with a D ring, any that may match online only have one bolt hole. Anyone got any ideas where I could source them from and also caps for those I may not use. Thanks in advance.
Anchor points replacement
- Thread starter maverick177uk
- Start date
You see these ones? I have two bolts too, but converter just fitted the single ones along with the proper spacer
Ebay link
Ebay link
No mine is just bolted direct to floor standard panel van, it’s has two bolts, could I get away with using a single bolt plastic insert and just leave one bolt in situ? The single plastic inserts are way cheaper than the double ones and tbh the lashing points won’t be having a huge amount of weight put through them.
Ye saw those mate a bit more expensive than the single ones, if your guy did a single with a spacer that sounds the way to go, I assume he left one bolt in floor and just used one in the new surround.
I have plastic inserts and single D rings I could supply to you if needed?
I’ll get back to mate, I don’t know how many I’ll need yet as furniture will cover a few of them.
No worries.
