Alpine sub underseat - wont fit?

[ant_liv]

Installing the alpine underseat sub - I noticed via a few videos that I may have to move a fuse or two to make it fit however the amount of fuses I have under my passenger seat seems a lot! I can't see how I can make room for them other than removing them from the plastic casing and having them just spread loosely around the little space the sub leaves.

Could anyone advise if this is the correct way forward please? Just doesn't seem right. Any advice would be appreciated. Cheers

Heres a photo of the fuses:

 

[Absolut5]

You will need to remove them from the plastic holders and I suggest wrapping them in foam to protect and stop rattles

One of our 10” sub enclosures in a Caravelle

 

[ant_liv]

You will need to remove them from the plastic holders and I suggest wrapping them in foam to protect and stop rattles

One of our 10” sub enclosures in a Caravelle

Thanks for the reply!

Have you had any trouble with the heat seat wiring not being long enough when having to go around the sub box? I've also fitted the kiravan swivel seat which means the wires have to go up through the centre of the swivel plate. Even at a push, it seems mine would snap off if sliding the seat fully back or forward...

 

[Absolut5]

Thanks for the reply!

Have you had any trouble with the heat seat wiring not being long enough when having to go around the sub box? I've also fitted the kiravan swivel seat which means the wires have to go up through the centre of the swivel plate. Even at a push, it seems mine would snap off if sliding the seat fully back or forward...

Some times you have to reroute the cables, or cut back some of the insulation to get more length then insulate again.. never had one where the cables are not long enough .