Search results for query: cable under passenger seat

Right the final bits turned up today, I need to get the seat off and have a proper measure up. But if I have to route the cables to the battery from under the passenger seat that should be OK. So this is how I think it should be connected. It's the order I would like to confirm... I was going...

I have a similar pop top with solar. My cable runs through a small hole at the front of the roof (sealed of course) then to the left hand B pillar, down inside the B pillar trim (where the passenger seat belt is) and pops out the bottom and then into my controller and battery. My battery is...

Thanks for that- I did all the leads and earths and new battery when it first started. Seemed to improve starting a bit (was just slow starting and the coil light then). Then it didn’t start but would if you kept trying (rocking in gear no help). Did that a few times weeks apart getting longer...

Hi thanks for responding. The seats are OEM from a German caravelle and our van is also German. In these photos you can see the control on the dash, and all of the cables and connections available under the passenger seat.

That chunky red cable in the second photo looks like the factory fit aux battery cable that is fed from the e-box. In my T6 I used mine to feed my Ring RSDC50 without issue. It was fused at SA8 with a 50a midi and only fed the dash cigarette lighter sockets. However, yours may feed some...

I suggest you try this for a bit to see if it works for you. Longer term you can get replacement rear panels that attach with magnets/screws in furniture ply that you can mount sockets and panels on...

Thanks! I didn't even know about the one under my seat! Thinking about retrofitting some heated seats from this now haha. I've attached what's under my seat And assuming this is what I'd need: link What would be the neatest way to tap/splice into this? - Also potentially a stupid question, but...

Can anybody recommend the best and/or easiest cable route to run from this fuse panel to under the passenger seat? I assume seats and floor will need removing?

I’m pretty sure there isn’t. It’s under the driver’s seat. The fault re-occurred a couple of weeks ago while I was re-fitting the lower centre dash panel (the one that covers the fuse panel and goes over the gear lever) from the passenger side whilst kneeling and leaning on the floor mat in...

Ok double you turn... Had a look at the alternative options. Had a look at the combi units, ie inverter chargers. Decided we don't need and 240v EHU in 96% of the time. So decided to go with the inverter only option. But 3kw ISH to convert the requirements. And one that could be N-PE...

So I finally got the time to add the MPPT. Thanks to everyone that helped answer my questions. I didn't have enough room under the drivers seat so had rlto route the battery cables to the passenger base which was surprisingly easy. Bit tight for space Cables pulled though without a snag...

Evening all, In our new van there is a fused biggish cable from the starter battery that feeds a power amp under the passenger seat . I’m thinking would it be possible to feed the power amp then carry it on to the charger / leisure battery. I’m just thinking of room, because I will also need to...

I had an issue with my oem towing socket when the off side position and stop lights stopped working. The nearest V W dealer did the diagnostics and said everything in the van was working. I subsequently removed the passenger seat and swivel and found that one of the fuses in the carrier pictured...

Wow, thanks for quick reply and info, that’s pretty fat cable, but I understand the reasons so it makes sense. It’s not got far to go to the passenger seat and hopefully I can get my 1000w inverter in there. I assume not to much of an issue getting the cables under the carpet between the seats...

So I think I've bought all I need for this now, then realised again that I don't understand electrics properly. I'll have two lights (total of six) on each dimmable switch/button. In trying to avoid voltage drop and wire issues, I was going to ground to the chassis local to the LED lights...

So after my solo T6 Spring camp:) I came away with four mods: strip lights on pop top, usb on VW badge, diffuser on exposed led strip and this one: Last year threw the orange "light of death" fridge out and replaced it with a chest fridge. In the camp discovered the 12v cable was long enough...

Hello Although iv read so many posts on all the leisure electrics set ups, my mind has “frozen” trying to work out what gear I need to order. So far, I’ve chosen a Roamer 160ah lithium battery,, to be fitted under passenger swivel. Hopefully some other Victron kit can fit in with this battery...

Hi, I'm new to the forum and have a question regarding my 2022 T6.1 Kombi. Under the single N/S passenger seat of a RHD Kombi is a long slim fuse box. This is fed by a fairly thick red wire which is permanently live and terminates and splits into a slightly thinner one and three thin ones which...

Update: I've wired the seats in using a combination of the above wiring diagram and the T6.1 heated seats diagram found in the VIP section and I still can't get them to work. As per the pic in post #6, I connected the wires under the passenger seat as follows: VAN - SEAT white -...

If you take out VIP Membership then you will have access to the wiring diagrams in the download section. It may be that it's not a bypass that you have fitted but the older design universal wiring kit that takes power direct from the lights? If you take a few pictures of what you have will...